Mounting the Lens

CAUTION: Before attaching the lens, check to make sure that the power of the projector is not turned on and the power cord is not connected. Failure to do so may cause electric shock or injuries.

1Unscrew the 6 screws using a Phillips screwdriver to remove the front cover2Remove the lens sheet attached to the lens mount at the front cover
6Connect the motor cableWhen a zoom lens is used

●Connect the zoom motor cable (3 pin) to “CN80Z0”, and the focus motor cable (2 pin) to “CN80F0”.

When a short focal length lens is used

●Connect the focus motor cable (2 pin) to “CN80F0”.

Front Cover

1

2

Lens Sheet

Top Panel

NOTE:

●Remove the top panel if possible to

ease the mounting process. For details on how to remove the top panel, please consult your authorized dealer or refer to the service manual.

7Clamp the motor cable

 

7

 

CN80F0 CN80Z0

Clamp

 

6

 

 

Focus Motor

 

 

Cable

Zoom Motor Cable

CAUTION:

 

● Keep the cable away from the motor gear when clamping the motor cable.

8 Unscrew the 2 shift lock screw
3Remove the lens cap of the end to be inserted into the projector

●When removing the lens cap, pull out without turning it.

●Do not scratch or knock the lens surface.

Lens Cap

Motor

4Insert lens into the mounting hole

●Insert the lens with the motor facing upward.

●Align the positioning pin of the projector (1 each on left and right sides) with the positioning pin of the lens.

5Tighten the 5 screws using the hexagonal wrench with a diagonal size of 3 mm (Bondhus type recommended) to fasten the lens

Positioning Pin

4 5

Positioning Pin

● Retain these shift lock screws for future use during transportation.

Shift Lock Screw

Shift Lock Screw

9Attach the front cover, and fasten using the 6 screws using a Phillips screwdriver

●Remove the lens cap before projection.

Lens Cap