7.TROUBLE SHOOTING
7.1PAN & TILT
Problem: No pan/tilt or lens functions.
Verify proper power is supplied to head.
Verify data is being sent to head.
7.2LENS CONTROL
Problem: No zoom or focus.
Verify lens control cable is plugged in pan and tilt head.
Verify lens control cable is plugged into correct Hirose cable on lens. Verify the gender of the connectors. It is possible to mix these up.
Problem: Zoom position returns to previous position when the zoom seesaw is released.
Check
7.3LDCC
Problem: No RCU functions.
Verify the camera is in the “REMOTE” mode. See the camera’s operation manual.
Verify RCU adapter cable is attached to rear panel of controller and
Verify LDCC cable (P/N: ACA96052200) is attached to “REMOTE” connector on the rear panel of the camera. Inspect the rubber boot on the
Verify “AUX2” switch is depressed.
Verify configuration of 4 conductor
Verify
There are several set up items on the controller which will also provide these symptoms. These are listed in the controller operation manual.
2/12/05 | 31 | Document D0153 |
|