Basic and Common Operations

Setting the Clock

Before operating the unit any further, first set the unit’s clock.

To show the clock when the unit is turned on

On the remote control ONLY:

When you plug in the power cord, “AM 12:00” starts flashing

Press DISPLAY.

DISPLAY

on the display.

You can set the clock when the unit is either turned on or in standby mode.

The clock indication appears on the display.

To return to the normal display, press DISPLAY

again.

On the remote control ONLY:

1 Press CLOCK/TIMER.

The hour digits start flashing on the display.

2 Press UP or DOWN to adjust the hour, then press CLOCK/ TIMER.

CLOCK/

TIMER

UP

DOWN

When playing an MP3 disc

Pressing DISPLAY shows the elapsed playing time instead of the clock time.

To change the clock

1 Make sure the (timer) indicator and the timer mode

indicator (DAILY) are not lit on the display.

• If they are lit, press and hold CLOCK/TIMER until they

go off.

The minute digits start flashing.

• When you press and hold

UP or

DOWN, the hour digit changes

continuously.

CLOCK/

 

TIMER

3 Press UP or DOWN to adjust the minute, then press CLOCK/TIMER.

The built-in clock starts.

2

Press CLOCK/TIMER repeatedly until the unit enters

 

the clock setting mode (the hour digits start flashing

 

on the display).

 

First time you press CLOCK/TIMER, the unit enters the

 

timer setting mode. (See page 20.)

3

Repeat steps 2 and 3 of the procedure “Setting the

 

Clock.”

4

Press and hold CLOCK/TIMER again so that the

 

(timer) indicator and the timer mode indicator

 

(DAILY) go off.

To turn off the clock indication (power save mode)

•When you unplug the power cord or if a power failure occurs The clock is reset to “AM 12:00” right away. If this happens, set the clock again.

•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.

On the remote control ONLY:

Press DISPLAY while the unit is in standby mode. DISPLAY “DISPLAY OFF” appears on the display and the

clock indication goes off.

To turn on the clock indication, press DISPLAY again while the unit is in standby mode. “DISPLAY ON” appears on the display.

9