12

Using the Tuner

English
Preset Tuning using the Unit
Press the PRESET TUNING button to select the de-
sired preset number.
Its band and frequency are displayed.
In AM broadcast, reception sensitivity will be changed by
turning the AM loop antenna. Turn the AM loop antenna
for best reception.

Presetting Stations

You can preset up to 30 FM stations and up to 15 AM sta-
tions using the Remote Control.
Preset numbers may have been set to factory test fre-
quencies prior to shipment. This is not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.

Manual Presetting

1Select a band by pressing the FM/AM
button.
2Press the 4 or ¢ button to tune in a
station.
3Press the SET button.
“SET” will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.
4Press the UP, DOWN, >, or < button
within 5 seconds to select the preset
number.
UP or DOWN button:Increase or decrease the preset
number by 1.
Pressing and holding the button
will continuously increase or de-
crease the preset number.
> or < button: Increase or decrease the preset
number by 1.
Pressing and holding the button
will rapidly increase or decrease
the preset number.
5Press the SET button within 5 seconds.
“STORED” appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations, repeat the same
steps as above.

Auto Presetting

In each band, you can automatically preset FM-30, AM-15
stations. Preset numbers will be allocated as stations are
found, starting from the lowest frequency and moving up
the frequency.
1Select a band by pressing the FM/AM
button.
2Press the AUTO PRESET button on the
Remote Control for more than two sec-
onds.
3Repeat steps 1-2 for the other band.
If you want to change the preset stations, carry out the
Manual Presetting for the desired preset numbers.
CAUTION:
Even if the system is unplugged or if the
power failure occurs, the preset stations
will be stored for about 24 hours. However,
in case the preset stations are erased, you
will need to preset the stations again.

To Change the FM

Reception Mode

When you are tuned into an FM stereo broadcast, the
“STEREO” indicator lights up and you can hear stereo ef-
fects.
If an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you
lose stereo effect.
Press the FM MODE button on the Remote Control
so that the “MONO” indicator ligh ts up on the di s-
play.
To restore the stereo effect, press the FM MODE button
on the Remote Control so that the “MONO” indicator goes off.
FM
/
AM SET DOWN
UP
SET STORED
SET
When changing the Band FM = 30, AM = 15
or
FM
/
AM
AUTO
PRESET
(for 2 seconds)
MONO
FM MODE
FS-SD5&7&9_A1.fm Page 12 Thursday, June 1, 2000 9:26 AM