EDITING EN 25
Dubbing To A Video Unit Equipped With A

To use this camcorder as a player

1 Make sure all units are turned off.

DV Connector (Digital Dubbing)

2 Connect this camcorder to a video unit equipped with

It is also possible to copy recorded scenes from the

a DV input connector using a DV cable as shown in the

illustration.

camcorder onto another video unit equipped with a DV

3 Set this camcorder’s Power Switch to “PLAY” while

connector. Since a digital signal is sent, there is little if

any image or sound deterioration.

pressing down the Lock Button located on the switch.

4 Turn on the video unit’s power.

 

 

 

 

5 Insert the source cassette in this camcorder.

 

 

6 Insert the recording cassette in the video unit.

 

 

7 Press 4/9 on this camcorder to start playback of the

 

 

source cassette.

 

 

8 At the point you want to start dubbing, engage the

 

 

video unit’s Record mode.

 

 

9 To pause dubbing, engage the video unit’s Record-

 

 

Pause mode and press 4/9 on this camcorder.

 

To DV OUT

10 Repeat steps 7 – 9 for additional editing. Stop the

 

 

video unit and camcorder.

 

 

NOTES:

 

 

● It is recommended to use the AC Adapter as the power

 

 

supply instead of the battery pack. ( pg. 7)

Core filter

DV cable

● If a blank portion or disturbed image is played back on the

 

(optional)

player during dubbing, the dubbing may stop so that an

 

 

unusual image is not dubbed.

 

 

● Even though the DV cable is connected correctly,

 

 

sometimes the image may not appear in step 8. If this

 

 

occurs, turn off the power and make connections again.

 

To DV IN

● If SNAPSHOT is pressed during playback, only the original

 

playback image recorded on the tape is output from the DV

 

 

 

 

connector.

 

Video unit equipped

● When using a DV cable, be sure to use the optional

 

JVC VC-VDV204U DV cable.

 

with DV connector