|
| TROUBLESHOOTING | EN 43 | |
|
|
| ||
|
| Warning Indications | ||
| Picture does not appear on the LCD |
| |||
| monitor. |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
●The viewfinder is pulled out and “PRIORITY” is set to “FINDER”.
HPush the viewfinder back in or set “PRIORITY” to “LCD”. ( pg. 18, 24, 27)
●The LCD monitor’s brightness setting is too dark. HAdjust the brightness of the LCD monitor.
HIf the monitor is tilted upward 180 degrees, open the monitor fully. ( pg. 18)
An error indication (01 – 04 or 06) appears.●A malfunction of some kind has occurred. In this case the camcorder’s functions become unusable.
H pg. 44.
The remote control does not work.●“REMOTE” is set to “OFF”.
HSet “REMOTE” to “ON”. ( pg. 24, 27)
●The remote control does not point at the remote
sensor.
HPoint at the remote sensor. ( pg. 22)
●The remote control batteries are exhausted.
Displays the battery remaining power.
Remaining power level
High | Exhausted |
As the battery power comes close to nil, the battery remaining power indicator blinks. When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded. ( pg. 16)
CHECK TAPE’S ERASE PROTECTION TABAppears when the erase protection tab is set to “SAVE” while the Power Switch is set to “A” or “M”. ( pg. 13)
USE CLEANING CASSETTEAppears if dirt is detected on the heads during recording. Use an optional cleaning cassette. ( pg. 47)
CONDENSATION, OPERATIONPAUSED PLEASE WAITAppears if condensation occurs. When this indication is displayed, wait more than 1 hour until condensation disappears.
TAPE!Appears if a tape is not loaded when the Recording Start/Stop Button or SNAPSHOT Button is pressed while the Power Switch is set to “A” or “M”.
TAPE END