TROUBLESHOOTING EN 49
|
| Warning Indications |
| The memory card cannot be removed from |
| |
| the camcorder. |
|
|
|
|
|
HPush in the memory card a few more times. ( pg. 17)
Picture does not appear on the LCD monitor.●The viewfinder is pulled out and “PRIORITY” is set to “FINDER”.
HPush the viewfinder back in or set “PRIORITY” to “LCD”. ( pg. 18, 31, 34)
●The LCD monitor’s brightness setting is too dark. HAdjust the brightness of the LCD monitor.
HIf the monitor is tilted upward 180 degrees, open the monitor fully. ( pg. 18)
An error indication (01 – 04 or 06) appears.●A malfunction of some kind has occured. In this case the camcorder’s functions become unusable.
H pg. 51.
The remote control does not work.●“REMOTE” is set to “OFF”.
HSet “REMOTE” to “ON”. ( pg. 31, 33)
●The remote control does not point at the remote
sensor.
HPoint at the remote sensor. ( pg. 23)
●The remote control batteries are exhausted.
Displays the battery remaining power.
Remaining power level
High | Exhausted |
As the battery power comes close to nil, the battery remaining power indicator blinks. When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded. ( pg. 16)
CHECK TAPE’S ERASE PROTECTION TABAppears when the erase protection tab is set to “SAVE” while the Power Switch is set to “A” or “M” and the VIDEO/MEMORY Switch is set to “VIDEO”. ( pg. 14)
USE CLEANING CASSETTEAppears if dirt is detected on the heads during recording. Use an optional cleaning cassette. ( pg. 53)
CONDENSATION, OPERATIONPAUSED PLEASE WAITAppears if condensation occurs. When this indication is displayed, wait more than 1 hour until condensation disappears.
TAPE!Appears if a tape is not loaded when the Recording Start/Stop Button or SNAPSHOT Button is pressed while the Power Switch is set to “A” or “M” and the VIDEO/MEMORY Switch is set to “VIDEO”.
TAPE ENDAppears when the tape ends during recording or playback.