VIDEO RECORDING EN 21
Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
Display
Quick Review
Enables to check the end of the last recording.
1) Press QUICK REVIEW during the Recording- |
Standby mode. |
2) Tape is rewound for about several seconds |
and played back automatically, then pauses in |
the |
12 : 34 : 24
Minutes
Seconds
Frames*
(30 frames = 1 second)
● Distortion may occur at start of playback. This is |
normal. |
Recording From The Middle Of A Tape
1)Play back a tape or use Blank Search
* Frames are not displayed during recording.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform Recording From The Middle Of A Tape ( pg. 21) in the following cases;
●When shooting again after playing back a recorded tape.
●When power shuts off during shooting.
●When a tape is removed and
●When shooting using a partially recorded tape.
●When shooting on a blank portion located partway through the tape.
●When shooting again after shooting a scene then opening/closing the cassette holder cover.
( pg. 22) to find the spot at which you want to start recording, then engage the Still Playback mode. ( pg. 22)
2)Set the Power Switch to “REC” while pressing down the Lock Button located on the switch, then start recording.
VIDEO RECORDING & PLAYBACK
NOTES:
●The time code cannot be reset.
●During
●The time code is displayed only when “TIME CODE” is set to “ON”. ( pg. 34)