TROUBLESHOOTING EN 43

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Picture does not appear on the LCD

 

SET DATE/TIME!

 

monitor.

 

 

 

 

● Appears when the date/time is not set.

● The viewfinder is pulled out and “PRIORITY” is

 

( pg. 15).

 

 

set to “FINDER”.

 

● The built-in clock battery has run out and the

➜Push the viewfinder back in or set “PRIORITY”

 

previously set date/time has been erased.

 

 

to “LCD”. ( pg. 8, 32)

 

➜Consult your nearest JVC dealer for

● The LCD monitor’s brightness setting is too

 

replacement.

 

 

dark.

 

 

 

➜Adjust the brightness of the LCD monitor.

 

UNIT IN SAFEGUARD MODE

 

 

( pg. 15)

 

REMOVE AND REATTACH BATTERY OR

➜If the monitor is tilted upward 180 degrees,

 

DC PLUG

 

 

open the monitor fully. ( pg. 8)

 

Error indications 01, 02 or 06.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Remedy: Remove and reattach the power supply

 

Aspect ratio is strange

 

 

or battery.

If the aspect ratio of the video you are playing is

 

 

 

strange, change the setting in “16:9 OUTPUT”.

 

UNIT IN SAFEGUARD MODE

( pg. 32, 33)

 

EJECT AND REINSERT TAPE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Error indications 03 or 04.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Remedy: Eject the cassette and reinsert.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

In the above 2 error indications, the camcorder

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

turns off automatically. Eject the cassette once

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

and re-insert it, then check if the indication clears.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

When it does, you can resume using the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

camcorder. If the indication remains, consult your

Displays the battery remaining power.

 

nearest JVC dealer.

Remaining power level

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

High

Exhausted

As the battery power comes close to nil, the battery remaining power indicator blinks.

When the battery power is exhausted, power turns off automatically.

TAPE END

Appears when the tape ends during recording or playback.

LENS CAP

Appears for 5 seconds after power is turned on if the lens cap is attached or when it is dark.

MEMORY IS FULL

Appears when the memory card’s memory is full and shooting is not possible.

REFERENCES