JVC GR-DF540 Operation Mode, Using AC Power, About Batteries, Power-LinkedOperation, OFF:, PLAY:, DANGER, VIDEO:, WARNING, MEMORY:, INFORMATION:, M (Manual Recording):

	GETTING STARTED EN 15
Using AC Power	M (Manual Recording):
Perform steps 4 – 5 in “Charging The Battery	Allows you to set various recording functions
	using the Menus. ( pg. 37)
Pack”.
	If you want more creative capabilities than Full
NOTE:
	Auto Recording, try this mode.
The provided AC Adapter features automatic	OFF:
voltage selection in the AC range from 110 V to
	Allows you to switch off the camcorder.
240 V.
	PLAY:
About Batteries
	● Allows you to play back a recording on the
DANGER! Do not attempt to take the batteries	tape.
apart, or expose them to flame or excessive	● Allows you to display a still image stored in
heat, as it may cause a fire or explosion.	the memory card or to transfer a still image
WARNING! Do not allow the battery or its	stored in the memory card to a PC.
terminals to come in contact with metals, as this	● Allows you to set various playback functions
can result in a short circuit and possibly start a	using the Menus. ( pg. 37)
fire.
To resume the original function of the	VIDEO/MEMORY Switch Position
accurate battery power indication	VIDEO:
If the battery power indication differs from the
	Allows you to record on a tape or play back a
actual operating time, fully charge the battery, and
	tape. If “REC SELECT” is set to “	/	”
then run it down. However this function may not
	( pg. 41), still images are recorded both on
turn back if the battery was used for a long period
	the tape and the memory card.
of time under extremely high/low temperature
condition or charged too many times.	MEMORY:
Operation Mode	● Allows you to record in a memory card or
	access data stored in a memory card.
To turn on the camcorder, set the Power Switch	● When the Power Switch is set to “A” or “M”,
	the currently selected image size appears.
to any operation mode except “OFF” while	Power-Linked Operation
pressing down the Lock Button located on the
switch.	When the Power Switch is set to “A” or “M”, you
Power Switch
	can also turn on/off the camcorder by opening/
Lock Button	closing the LCD monitor or pulling out/pushing in
	the viewfinder.
	INFORMATION:
	The following explanations in this manual
	supposes the use of LCD monitor in your
	operation. If you want to use the viewfinder,
POWER/	close the LCD monitor and pull out the
CHARGE lamp	viewfinder fully.
VIDEO/MEMORY

GETTING STARTED

Choose the appropriate operation mode according to your preference using the Power Switch and VIDEO/MEMORY Switch.

Power Switch PositionA (Full Auto Recording):

Allows you to record using NO special effects or manual adjustments. Suitable for standard recording.

The “A” indicator appears on the display.