DETAILS | EN 47 | |
|
| |
I T E M S | N O T E S | |
|
| |
➪ Power | ❍ Perform charging where the temperature is between 10°C and 35°C. 20°C to | |
( pg. 8) | 25°C is the ideal temperature range for charging. If the environment is too | |
cold, charging may be incomplete. | ||
| ||
| ❍ Charging times are for a fully discharged battery pack. | |
| ❍ Charging time varies according to the ambient temperature and the status of | |
| the battery pack. | |
| ❍ To avoid interference with reception, do not use the AC Adapter near a radio. | |
| ❍ Since the AC Adapter processes electricity internally, it becomes warm | |
| during use. Be sure to use it only in | |
| ❍ The following operation stops charging: | |
| • Set the Power Switch to “PLAY”, “ ” or “ ”. | |
| • Disconnect the AC adapter from the camcorder. | |
| • Unplug the AC adapter from the AC outlet. | |
| • Detach the battery from the camcorder. | |
|
| |
➪ RECORDING | ❍ When you use the LCD monitor outdoors in direct sunlight, the LCD monitor | |
( pg. 15, 16) | may be difficult to see. If this happens, use the viewfinder instead. | |
❍ The cassette holder cannot be opened unless a power supply is attached. | ||
| ||
| ❍ There may be a delay after you open the cassette holder cover until the | |
| cassette holder opens. Do not use force. | |
| ❍ Once the cassette holder is closed, it recedes automatically. Wait until it | |
| recedes completely before closing the cassette holder cover. | |
| ❍ When the Recording Start/Stop button is pressed, it may take a few seconds | |
| before actual recording starts. “ ” starts rotating when the camcorder | |
| actually starts recording. | |
| ❍ The time required to calculate and display the remaining tape length, and the | |
| accuracy of the calculation, may vary according to the type of tape used. | |
| ❍ “TAPE END” appears when the tape reaches its end, and the power goes off | |
| automatically if left in this condition for 5 minutes. “TAPE END” also appears | |
| when a cassette at its end is loaded. | |
|
|