42 EN
I T E M S N O T E S
❍
Perform charging where the temperature is between 10°C and 35°C
(50°F and 95°F). 20°C to 25°C (68°F to 77°F) is the ideal temperature
range for charging. If the environment is too cold, charging may be
incomplete.
❍Charging times are for a fully discharged battery pack.
❍Charging time varies according to the ambient temperature and the
status of the battery pack.
❍To avoid interference with reception, do not use the AC Adapter
near a radio.
❍Since the AC Adapter processes electricity internally, it becomes
warm during use. Be sure to use it only in well-ventilated areas.
❍The following operation stops charging or discharging:
•Set the Power Switch to “ ”, “ ” or “ ”.
•Disconnect the AC Adapter from the camcorder.
•Unplug the AC Adapter’s power cord from the AC outlet.
•Detach the battery from the camcorder.
❍The date/time cannot be stored in memory if the built-in clock
battery runs out. Consult an authorized JVC dealer for replacement,
or set the date/time as necessary before you start shooting.
❍When the Power Switch is set to “ ” or “ ” and the LCD
monitor is opened at an angle of 60 degrees or more, the LCD
monitor switches on and the viewfinder switches off automatically
to save power.
❍
The cassette holder cannot be opened unless a power supply is attached.
❍There may be a delay after you slide EJECT until the cassette holder
opens. Do not use force.
❍
The time required to calculate the remaining tape length, and the
accuracy of the calculation, may vary according to the type of tape used.
❍The tape remaining time indicator is correct only if the correct tape
length has been selected (墌 pg. 12).
❍“TAPE END” appears when the tape reaches its end, and the power
goes off automatically if left in this condition for 5 minutes.
“TAPE END” also appears when a cassette whose tape is already at
its end is loaded.
❍If the Recording Start/Stop button is pressed after the Record-
Standby mode has continued for over 5 minutes, recording may not
start immediately.
❍While shooting, sound is not heard from the speaker.
❍The “TBC” indicator turns green (gray with a camcorder equipped
with a black/white viewfinder) while TBC is working.
❍TBC does not work during still playback and shuttle search.
❍The “TBC” indicator turns white while TBC is not operative.
❍It may take a few seconds before TBC actually starts working.
❍The picture may be distorted if the TBC mode is activated or
deactivated at the edit-in/-out points or when normal playback
resumes after still playback or shuttle search.
❍If the playback picture is distorted when TBC is set to on, turn off TBC.
DETAILS➪Date/Time
Settings
(墌 pg. 9)
➪Power
(墌 pg. 6)
➪TBC
(Time Base
Corrector)
(墌 pg. 31)
➪Recording
(墌 pg. 14, 15)