Remote sensor

!

 

 

OF

A

 

 

Y

F

 

M

L

A

 

 

 

P

 

 

 

 

@

T Ys a

A lS ;

RM-V700U (optional)

SELECT SCENES

4)Point the remote control at the camcorder’s remote sensor. Press PLAY T , then press ON/OFF S on the remote control. The R.A. Edit counter display appears.

5)Press REW Y or FF a to locate the beginning of the scene you want, then press IN/OUT l to register that point. The data appears under “IN” on the display.

6)Press REW Y or FF a to locate the end of the scene and press IN/OUT l to register it.

•The data appears under “OUT” on the display.

•The total time of the registered scene(s) is displayed at the bottom of the screen.

7)Repeat steps 5 and 6 for each additional scene (as many as 8).

8)To make corrections, press CANCEL ; during steps 5 and 6 to erase the most recently registered point.

•There must be at least one second between an in-point and its corresponding out-point.

•To ensure correct operation, there should be at least 15 seconds between an out-point and the next in-point.

•Blank portions of a tape cannot be registered as in-points or out-points.

•If it takes more than 5 minutes to search for an in- point, the VCR’s Record-Pause mode is cancelled and editing does not take place.

•Pressing ON/OFF S clears all in- and out-points from memory.

•Leave a small margin for error around each in- point to ensure the scene is recorded in its entirety.

•Turning off the camcorder’s power erases all registered in- and out-points.

AUTOMATIC EDITING TO VCR

9)Rewind the tape in the camcorder to the

beginning of the scene you want to edit and press PAUSE s.

10)Point the remote control towards the VCR’s infrared sensor and press VCR REC STBY A, or manually engage the VCR’s Record-Pause mode.

11)Press the Recording Start/Stop Button on the camcorder to begin Automatic Editing, and the previously selected scenes are copied to the VCR in the specified order.

While editing, the R.A. Edit counter of the scene which is being copied is shown with a

blinking highlight.

•Pressing START/STOP P on the remote control does not start editing.

12)When all selected scenes have been copied, the camcorder and VCR enter the Still or Pause mode. Press STOP $ and U. To make the R.A. Edit counter display disappear, press

ON/OFF S.

•When finished editing, be sure to disconnect the editing cable and the A/V cable.

•If you performed step 1 on page 27 (“MAKE CONNECTIONS”), keep the remote control pointed at the VCR during editing.

•The on-screen display only appears while the camcorder searches for each scene.

•There may be noise at in- or out-points on the edited tape with certain VCRs.registered in- and out-points.

28