18 EN

REFRESH Button

Makes the DSC lamp go out.

 

During shooting

Power Switch

 

Recording Start/Stop Button

 

2 5M I N

Tape remaining

 

time indicator

 

(Approximate)

MIN 120MIN 119MIN

(Now calculating)

0MIN 1MIN 2MIN 3MIN

(Blinking) (Blinking) (Blinking)

VIDEO RECORDING

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

●Power ( pg. 8)

●Load A Cassette ( pg. 15)

●Recording Mode Setting ( pg. 14)

●Tape Length Setting ( pg. 14)

●Grip Adjustment ( pg. 10)

●Viewfinder Adjustment ( pg. 10)

Shooting While Watching The Viewfinder

1 Make sure the LCD monitor is closed and locked. Press in the tabs on the lens cap to remove it. Set the Power Switch to “” or “”. If the DSC Lamp is lit, press REFRESH for approx. 1 second to select “VIDEO”. The VIDEO Lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed in the viewfinder.

2 Press the Recording Start/Stop Button. “” appears

in the viewfinder while recording is in progress.

To Stop Recording . . .

.... press the Recording Start/Stop Button. The camcorder

re-enters the Record-Standby mode.

Shooting While Watching The LCD Monitor

180°

BRIGHT Wheel

90°

1 Make sure the LCD monitor is fully open. Press in the tabs on the lens cap to remove it. Set the Power Switch to “” or “”. If the DSC Lamp is lit, press REFRESH for approx. 1 second to select “VIDEO”. The VIDEO Lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed in the LCD monitor.

2 Tilt the LCD monitor upward/downward for best viewability and press the Recording Start/Stop Button. “” appears in the LCD monitor while recording is in progress.

BR I GHT – – – – – – – –6– – – +

To Adjust The Brightness Of The LCD Monitor

.... rotate the BRIGHT Wheel until the bright

level indicator on the display moves and the appropriate brightness is reached.

NOTE:

When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this happens, use the viewfinder instead.

To Stop Recording . . .

.... press the Recording Start/Stop Button. The camcorder

re-enters the Record-Standby mode.

Power Switch Position

:Suitable for standard recording using NO special effects or manual adjustments.

: Allows you to set recording functions using the menus for more creative capabilities. OFF : Switches off the camcorder.

: Allows you to play back your recordings.