56 EN

2. Store cassettes . . .... away from heaters or other heat sources.... out of direct sunlight.... where they won’t be subject to unnecessary shock or vibration.

... where they won’t be exposed to strong magnetic fields (such as those generated by motors, transformers or magnets).

... vertically, in their original cases.

Main Unit

1. For safety, DO NOT . . ..... open the camcorder’s chassis..... disassemble or modify the unit..... short-circuit the terminals of the battery pack. Keep itaway from metallic objects when not in use..... allow inflammables, water or metallic objects toenter the unit..... remove the battery pack or disconnect the powersupply while the power is on..... leave the battery pack attached when thecamcorder is not in use.2. Avoid using the unit . . ..... in places subject to excessive humidity or dust..... in places subject to soot or steam such as near acooking stove..... in places subject to excessive shock or vibration..... near a television set.

.... near appliances generating strong magnetic or electric

fields (speakers, broadcasting antennas, etc.)..... in places subject to extremely high (over 40°C or104°F) or extremely low (under 0°C or 32°F) temperatures.3. DO NOT leave the unit . . ..... in places of over 50°C (122°F)..... in places where humidity is extremely low (below35%) or extremely high (above 80%)..... in direct sunlight..... in a closed car in summer..... near a heater..... in dusty places such as a beach.4.To protect the unit, DO NOT . . ..... allow it to become wet..... drop the unit or strike it against hard objects..... subject it to shock or excessive vibration during transportation..... keep the lens directed at extremely bright objects for long periods..... direct the eyepiece of the viewfinder at the sun.

.... carry it by holding the viewfinder or the LCD monitor. Be sure to hold the main unit with both hands or use the grip.

.... swing it excessively when using the shoulder strap.
CAUTIONS (cont.)

LCD Monitor

1.To prevent damage to the LCD monitor, DO NOT . . ..... push it strongly or apply any shocks..... place the camcorder with the LCD monitor on the bottom.2.To prolong service life . . ..... avoid rubbing it with coarse cloth.

3.Be aware of the following phenomena for LCD monitor use. These are not malfunctions:

•While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

•If you leave power on for a long time, the surface around the LCD monitor becomes hot.

How To Handle a CD-ROM

•Take care not to soil or scratch the mirror surface (opposite to the printed surface). Do not write anything or put a sticker on either the front or back surface. If the CD-ROM gets dirty, gently wipe it with a soft cloth outward from the center hole using a circular motion.

•Do not use conventional disc cleaners or cleaning spray.•Do not bend the CD-ROM or touch its mirror surface.

•Do not store your CD-ROM in a dusty, hot or humid environment. Keep it away from direct sunlight.

About moisture condensation . . .

●You may have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass’ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

●Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.