Necessary Settings before Use
Power/Mode
Switch
Access/Charge
Lamp
3 Connect the AC adapter.
| DC Connector |
| AC Adapter |
Set Lever | To AC Outlet |
(110V to 240V) |
Be sure to configure the following three settings before use.
Charging the Battery Pack
1 Set the power/mode switch to OFF.
Slide while pressing down the lock button.
OFF (CHARGE)
2 Attach the battery pack.
Slide the battery pack down until it locks in place.
BATT.
•The access/charge lamp blinks to indicate charging has started.
•When the lamp goes out, charging is finished. Unplug the AC adapter from the AC outlet and disconnect the AC adapter from the camera.
Required charging / recording time (approx.)
Battery pack | Charging time | Recording | |
time | |||
|
| ||
2 hr. 40 min. | 1 hr. 20 min. | ||
(Provided) | (1hr. 25 min.*) | ||
|
|
| |
3 hr. 50 min. | 2 hr. 00 min. | ||
(2 hr. 10 min.*) | |||
|
|
|
* When using the viewfinder.
8 To detach the battery pack
Slide and hold BATT. ( step 2), then remove the battery pack.
8 To check the remaining battery power See page 18.
NOTES
•You can also use the camera with just the AC adapter.
•Please do not pull or bend the AC adapter plug and cable. This may damage the AC adapter.
16