JVC GZ-MG70U Warning Indications, camera, whitish, monitor, LENS CAP, HDD ERROR, SET DATE/TIME, MEMORY IS FULL, 54 EN REFERENCES, MEMORY CARD ERROR, (Battery indicator)

54 EN REFERENCES

Images on the LCD monitor appear dark or			Warning Indications
whitish.
● In places subject to low temperature, images
	The following indications appear on the screen.
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.			(Battery indicator)
HAdjust the brightness and angle of the LCD
	Displays the battery remaining power.
monitor. ( pg. 9, 18, 49)
	Remaining power level
● When the LCD monitor's fluorescent light reaches
the end of its service life, images on the LCD
monitor become dark.	High				Exhausted
HConsult your nearest JVC dealer.
	● As the battery power comes close to nil, the
Colored bright spots appear all over the LCD
		battery indicator blinks. When the battery power
monitor.		is exhausted, power turns off automatically.
● The LCD monitor is made with high precision	SET DATE/TIME!
technology. However, black spots or bright spots	● Appears when the date/time is not set. ( pg. 18)
of light (red, green or blue) may appear constantly
	● Appears when the built-in clock (lithium) battery is
on the LCD monitor. These spots are not		discharged and the previously set date/time is
recorded on the picture. This is not due to any
		erased. ( pg. 18)
defect of the unit. (Effective dots: more than
	LENS CAP
99.99 %)
	Appears for 5 seconds after power is turned on
The SD card cannot be removed from the
	with the power switch set to			, if the lens cap is
camera.
	attached or when it is dark.
HPush in the SD card a few more times. ( pg. 19)
	PLEASE INSERT MEMORY CARD!
Picture does not appear on the LCD monitor.
	Appears when no SD card is inserted in the SD
● The LCD monitor's brightness setting is too dark.
	slot. ( pg. 19)
HAdjust the brightness of the LCD monitor.
	HARD DISK DRIVE IS NOT FORMATTED
( pg. 18, 49)

Appears when the built-in hard disk needs to be formatted.

THIS CARD IS NOT FORMATTED Appears when an unformatted SD card is inserted.

HARD DISK DRIVE IS FULL

Appears when the built-in hard disk is full and recording is not possible.

MEMORY IS FULL

Appears when the SD card is full and recording is not possible.

HDD ERROR!

MEMORY CARD ERROR!

Appears when some errors occured with the recording media.

● Remove the card once and insert it again. If the error is not cancelled, replace the card with one that has been guaranteed for correct operation. ( pg. 19, 62)

● Perform clean up to restore the capacity of the recording media. ( pg. 40)

● It is recommended to run check disk regularly on the PC, on condition that there is no data on the hard disk of the camera.