JVC HA-NC100-J/C Parts List, Battery Insertion, Using The Headphones, Folding The Headphones

PARTS LIST

1	Headband	1
2	Slider	2

3Earpad

4	Housing	6	4
5	Retractable Cord	3
		9
6	Rewind Switch
		10
7	Battery Cover
8	Power Switch	5

9Operation Indicator

10 Cord Housing 7

8

BATTERY INSERTION

1.Slide open the battery cover on the right housing.

2.Insert the provided battery, matching the and . Press in on end first and down on end.

3.Close the battery cover.

+

-

Changing the Battery

The battery should be changed when the Operation Indicator fades or does not turn on. The Noise Canceling Function becomes less effective as the battery wears down so make sure to replace the battery as necessary to maintain the proper performance of the headphones.

NOTES: Misuse of battery could result in leakage. This could cause a fire or explosion. To prevent this, pay special attention to the following points:

• Be sure to insert the battery with correct positive and negative polarities.

•Do not heat, disassemble or short-circuit battery and never dispose of battery by throwing them in a fire.

•Read the caution displayed on the battery when in use.

USING THE HEADPHONES

1.When the power is OFF, the headphone operates without noise canceling function.

2.When the power is ON, the headphone operates with noise canceling function.

3.Rewind the cord and turn the power ON to use the noise canceling function like an ear plug (e.g. while sleeping on airplane or train)

•Select the appropriate plug adaptor that fits in the airplane headphone plug.

FOLDING THE HEADPHONES

1.Push up the slider on both ends.

2.Place the earpads together.

3.Fold the housing at both ends and push up from the bottom.

HOW TO PULL-OUT/REWIND THE CORD

Pull out: Slowly pull out the cord to the desired length. Maximum cord length is 4.9ft (1.5m); stop pulling when the cord end mark appears.

Rewind: Remove the headphones, fold it up, and then slide the rewind switch. (To prevent

accidents, the headphone

end

is designed not to rewind mark when it is in use or

while wearing it.)

■If the cord doesn't wind in completely, pull it out and try rewinding again.

SPECIFICATIONS English

Frequency response:	10Hz — 22,000Hz
Noise cancellation	40Hz — 1,500Hz
frequency range:
Noise reduction:	more than 12 dB at 300Hz
Sensitivity:	100dB/1mW (when ON), 103dB/1mW (when OFF)
Input impedance:	36Ω (when ON), 64Ω (when OFF)
Power supply:	AAA battery (DC 1.5V) x 1
Battery life*:	approx. 25 hours** (using Manganese AAA battery),
	approx. 50 hours** (using Alkaline AAA battery)
	*Varies on operating conditions. **Without ambient noise.
Cord length:	0 — 1.5m (4.9ft) (with L type stereo miniplug)
Mass:	200g (7.06oz) (incl. cord and battery)
Accessories:	carrying pouch x 1, AAA battery (R03) x 1,
	dual plug adapter (for in-flight use) x 1
	Design and specifications subject to change without notice.