JVC HD-Z70RF7, HD-Z70RF7, HD-Z61RF7 Initial settings, Begin, Select a language, Select the teletext language group, Automatically register channels, Check what was registered, Confirm

ENGLISH

Initial settings					After turning off the TV, it takes about 5 seconds to
					After turning on the TV, it takes about 1 minute to
					project the picture to its full brightness.
					make the screen dark. After that, cooling is performed
Set the menu language, installation location and automatically register the TV channels.					for about 1 minute.
					“About the LAMP indicator” (P. 6)
These channels can be edited later in “Editing channels” (P. 9).
			1	Begin		The remote control doesn’t
						work
					Shown only when powering on for the fi rst time.	Confi rm the mode is set to “TV”.
					The power button on the remote control can also be
HD-Z70RF7	HD-Z61RF7
					used.
		When you press the Power button of the HD-Z61RF7,	2	Select a language
		recommend that press below of the button.		> Language	select
					set
			3	Select the teletext language group		For the teletext language group
					select
				> Teletext Language		“Language group for teletext”
				Group-1		(P. 22)
				Group-3
				Group-2		If the characters are unreadable
				Group-5
				Group-4
						“Language group for teletext”
						(P. 22)
			4	Automatically register channels
					>> Auto Program
					CH 28
	TV	MENU			14%

	BACK
	5	Check what was registered
		> Edit			Edit channels
		PR ID	CH/CC
		AV	CH	21
		01			in “Editing channels” (P. 9)
		02	CH	22
		03	CH	23
		04	CH	24
		05	CH	25
		06	CC	02
To the previous screen		07	CC	03
		08	CC	04
		09	CC	05
Exit	6	Confirm
If the “JVC” logo does not appear or if
you wish to make changes later
“Language”, “Teletext Language” and
“Auto Program” (P. 18)

8