JVC HR-J457MS Basic Connections, Check Contents, Situate Recorder, Mains, Connect Recorder To

INSTALLINGYOURNEWRECORDER

EN

3

Basic Connections

Aerial terminal

RF Cable (provided)

Back of TV
AV-IN terminals		TV
	AV Cable	Aerial
		Cable
	(not provided)

Mains Power

Cord

Rear View

Mains outlet

AUDIO OUT/

VIDEO OUT

Connect the power plug to an AC outlet before installing the lithium battery. ☞ pg. 5

It's essential that your video recorder be properly connected. Follow these steps carefully. THESE STEPS MUST BE COM-

PLETED BEFORE ANY VIDEO OPERATION CAN BE PER- FORMED.

	CHECK CONTENTS
	Make sure the package contains all of the accessories
1 listed in “Specifications” (☞ pg. 37).
	SITUATE RECORDER
2 Place the recorder on a stable, horizontal surface.
	CONNECT RECORDER TO
3	TV
	The connection method you use depends on the type
	of TV you have.
	RF CONNECTION
	● To Connect To A TV With NO AV Input Terminals . . .
	a– Disconnect the TV aerial cable from the TV.
	b– Connect the TV aerial cable to the ANT. IN jack
	on the rear panel of the recorder.
	c– Connect the provided RF cable between the RF
	OUT jack on the rear panel of the recorder and
	the TV’s aerial terminal.

AV CONNECTION

●To Connect To A TV With AV Input Terminals . . .

a– Connect the aerial, recorder and TV as per “RF

CONNECTION”.

b– Connect an optional AV cable between the AUDIO OUT and VIDEO OUT connectors on the rear panel of the recorder and the TV’s AV-IN terminals .

	CONNECT RECORDER TO
4	MAINS
	Plug the end of the mains power cord into a mains
	NOTE:outlet.
	Use the conversion plug (not provided in certain areas)
	depending on the type of your AC wall outlet.

ATTENTION

If you have finished all the necessary connections, go to "Video Channel Set" on page 4, then perform Auto Set Up on

page 6; do NOT press the button on the recorder/remote control to turn on the recorder's power before you start Auto Set Up.