February 8, 2003 4:06 pm Page 1 4
—14—
Master Page: Right
Deleting a channel
AAccess Confirmation screen
Perform s tep 1
11
1 of “Manual Channel Set” (墌13).
BSelect position
Press rt w e to until the channel you want to delete begins
blinking.
CDelete channel
Press &. The channel directly beneath the cancelled one moves
up one line.
●Repeat steps2
22
2–3
33
3 as necessary.
DReturn to normal screen
Press MENU.
Changing station channel positions
AAccess Confirmation screen
Perform s tep 1
11
1 of “Manual Channel Set” (墌13).
BSelect position
Press rt w e until the station you want to move begins blinking,
then press OK. The channel number (CH) and the station name
(ID) begin blinking.
CSelect new position
Press rt w e to move the station to the new position, then press
OK.
Example: If you moved the station in position 4 to position 2, the
stations originally in positions 2 and 3 each move down one
space.
●Repeat steps2
22
2–3
33
3 as necessary.
DReturn to normal screen
Press MENU.
When receiving a scrambled broadcast
NOTE:
When you select a country in Central or Eastern Europe for
country setting, you cannot use decoder with this recorder.
ASelect decoder mode
Set “L-2 SELECT” to “DECODER”. (墌10)
BAccess Confirmation screen
Perform s tep 1
11
1 of “Manual Channel Set”.
CSelect position
Press rt w e to select the channel broadcasting scrambled
programmes, then press OK twice.
DChange decoder setting
Press e until “OFF” begins blinking, and set it to “ON” by
pressing rt. Then press OK.
●Repeat steps3
33
3–4
44
4 as necessary.
EReturn to normal screen
Press MENU.
Changing station name
AAccess Confirmation screen
Perform s tep 1
11
1 of “Manual Channel Set” (墌13).
BSelect position
Press rt w e until the desired channel begins blinking, then
press OK twice. The Manual Channel Set screen appears.
CSelect station name
If the station name is registered in your
recorder,
Press e until the station name (ID) begins
blinking. Press rt until the desired
station name appears, then press OK.
Repeat steps 2
22
2–3
33
3 as necessary.

Otherwise,

Press e until the first letter of the station
name (ID) begins blinking. Press rt to
cycle through the characters, then press
e. Enter the remaining characters the
same way (maximum of 4). After entering
all characters, press OK.
●The characters available for the station
name (ID) are A-Z, 0-9, –, *, +, _ (space).
●If you make a mistake, press w until the incorrect character
begins blinking. Then enter the correct character by pressing
rt.
DReturn to normal screen
Press MENU.
Fine-tuning channels
AAccess Confirmation screen
Perform s tep 1
11
1 of “Manual Channel Set” (墌13).
BSelect position
Press rt w e until the channel you want to tune begins blinking,
then press OK twice. The Manual Channel Set screen appears.
CPerform tuning
Press e until “+/–” begins blinking, then press rt until the
picture is its clearest. Then press OK.
●Repeat steps 2
22
2–3
33
3 as necessary.
DReturn to normal screen
Press MENU.
HR-S5960.5961_001EN.fm Page14 Saturday, February8, 2003 4:07 PM