10plug&play setup

Plug&Play Setup

The TV should be set to its AV mode (if you are using both the RF cable and 21-pin SCART cable for connection) or UHF channel 52 (if you are using only RF cable for connection).

Start Plug&Play Setup

before you start Plug the mains power cord into a mains outlet.

Check that the note Turn on the VCR. connection is completed

Tune the TV to your what will happen? The Plug&Play screen

Video Channel or to its appears on the TV screen. Then press OK.

AV mode

Load the batteries into the Remote Control

Refer to the Remote Control diagram on pages 6–7

Unless indicated otherwise, use the buttons on the Remote Control

NOTE:

If you have connected your TV to the VCR with only the RF cable and the on-screen display appearing on UHF channel 52 looks distorted, perform “Video Channel Set” on page 14.

The VCR is automatically setting up the tuner channels. This only happens the first time that you plug the main power cord into the main outlet.

When Plug&Play is completed, the Confirmation screen appears.

ACMS

01

C03

00

PR01

 

01

C03

00

PR01

 

 

 

 

 

 

 

 

 

02

C02

00

PR02

 

 

 

 

 

 

 

 

03

S40

00

PR03

 

 

 

 

 

 

 

 

04

S11

00

PR04

 

 

 

 

 

 

 

 

05

C02

00

PR05

 

 

 

 

 

 

 

 

06

- -

- -

- - - - -

 

 

 

 

 

 

 

 

 

 

 

07

- -

- -

- - - - -

 

 

 

 

 

 

 

 

 

 

 

08

- -

- -

- - - - -

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MOVE:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DELETE: