•“AUTO” setting for “DIMMER” may not work correctly on some vehicles, particularly on those having a control dial for dimming. In this case, change the “DIMMER” setting to any other than “AUTO.”
•If you change the “AMP GAIN” setting from “HIGH PWR” to “LOW PWR” while the volume level is set higher than “VOL 30,” the unit automatically changes the volume level to “VOL 30.”
Title assignment
•If you try to assign titles to more than 30 discs, “NAMEFULL” appears. Delete unwanted titles before assignment.
•Titles assigned to discs in the CD changer can also be shown if you play back the disc from the unit and vice versa.
• Only primary DAB services can be presetted | ENGLISH | |
even when you store a secondary service. | ||
| ||
• A previously preset DAB service is erased |
| |
when a new DAB service is stored in the same |
| |
preset number. |
|
Maintenance
How to clean the connectorsFrequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the connectors with a cotton swab or cloth moistened with alcohol, being careful not to damage the connectors.
iPod® or D. player operations 
•When you turn on this unit, the iPod or D. player is charged through this unit.
•While the iPod or D. player is connected, all operations from the iPod or D. player are disabled. Perform all operations from this unit.
•The text information may not be displayed correctly.
– Some characters such as accented letters cannot be shown correctly on the display.
– Depends on the condition of communication between the iPod or D. player and the unit.
•If the text information includes more than 8 characters, it scrolls on the display (see also page 17). This unit can display up to 40 characters.
Notice:When operating an iPod or a D. player, some operations may not be performed correctly or as intended. In this case, visit the following JVC web site:
For iPod users: <http://www.jvc.co.jp/
For D. player users: <http://www.jvc.co.jp/
Connector
Moisture condensationMoisture may condense on the lens inside the CD player in the following cases:
•After starting the heater in the car.
•If it becomes very humid inside the car. Should this occur, the CD player may malfunction. In this case, eject the disc and leave the unit turned on for a few hours until the moisture evaporates.
How to handle discsWhen removing a disc from | Center holder |
its case, press down the center |
|
holder of the case and lift the |
|
disc out, holding it by the edges. |
|
•Always hold the disc by the
edges. Do not touch its recording surface.
When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up).
•Make sure to store discs into the cases after use.
Continued on the next page
25