INSTALLATION

If you are not sure how to install this unit correctly, consult your JVC car audio dealer.

In dash-mounting

 

Removing the unit

 

 

 

Before removing the unit, release the rear section.When you stand the unit, be carefulnot to damage the fuse on the rear.Do the required electrical connections.Bend the appropriate tabs to hold the sleeve firmly in place.
INSTALLATION / CONNECTION

When using the optional stay

Fire wall

Stay (option)

DashboardScrew (option)Install the unit at an angle of less than 30˚.

When installing the unit without using the sleeve

In a Toyota car for example, first remove the car radio and install the unit in its place.

Flat type screws

* Not supplied for this unit.

—M5 ⋅ 8 mm (M5 ⋅ 3/8")*

 

Bracket*

 

 

Flat type screws

Pocket—M5 ⋅ 8 mm (M5 ⋅ 3/8")*

 

Bracket*

 

ELECTRICAL CONNECTIONS

Make sure to disconnect the battery’s negative terminal.• Be sure to ground this unit to the car’s chassis again after installation.
Note:
High

 

It is recommended to connect to the speakers with maximum power of more than 45 W (both at the rear and at the front,

 

with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 45 W, change “AMP GAIN” setting to prevent the

Heat sink

speakers from being damaged (see “General settings—PSM”).

Typical connections

Rear ground terminal

Line out

Connecting the external amplifier or subwoofer

Remote lead

Y-connector *1

Antenna terminal

Connect only the front speakers if your speaker system is two-speaker system.

White with black stripe
Front speaker (left)

White

 

15 A fuse
Black

To metallic body or

 

 

chassis of the car

To a live terminal in the

Yellow *2 fuse block connecting to the car battery (bypassing the

ignition switch) (constant 12 V)
Ignition switchFuse block
Set “L/O MODE” to “REAR”(See “General settings—PSM.”)You can connect a power amplifier for rear speakers.JVC Amplifier Rear speakers
Remote lead (blue with white stripe)

To the remote lead of other equipment or automatic antenna if any

Front speakers
Gray with black stripe
Front speaker (right)

Gray

Red

To an accessory terminal in

 

the fuse block
Set “L/O MODE” to “WOOFER” (See “General settings—PSM.”)You can also connect a subwoofer to the REAR LINE OUT terminals.
Green with black stripe
Rear speaker (left)

Green

Purple with black stripe
Blue with whitestripeTo the remote lead of other equipment or automatic antenna ifany (200 mA max.)

JVC Amplifier

Subwoofer
Rear speaker (right)

Purple

PRECAUTIONS on power supply and speaker connections
*1 Not supplied for this unit.

*2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.

*3 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.

*4 Signal cord (not supplied for this unit)4 – EN