JVC 1299-TN-JII-JMT, LCT0614-001A-H POWER, ADJUSTING VOLUME, CHANGING CHANNELS

10 Getting Started

To move directly to a specific channel, press that channel's numbers on the remote's 10 key pad. For single-digit

channel numbers, press "0" then the channel number. For channels above 100, press the 100+ button, then the

remaining two digits on the 10 key pad.

To scan through the channels, press either the CH A N N E L+ ( ) or CHANNEL - ( ) button on the remote or

T V / V C R ’s front panel and release. You will move through the channels in numerical ord e r .

• After you operate the Auto Tuner Setup (page 13), all of the empty channels will be removed from scanning.

When you scan you will only receive clear, active channels.

H y p e rs c a n

With JVC's Hyperscan feature you can zip through the channels at a rate of five per second. To use Hyperscan,

p ress and hold either the CH A N N E L+ or CH A N N E L-buttons. After the first few channels scan at normal speed, the

rest will move by at five per second. To scan at normal speed, press and release the CH A N N E L + / -b u t t o n .

P ress and release the RE T U R N+button to re t u rn to the previous channel viewed. For example select a channel.

Then select another channel using the 10 key pad buttons. You can now flip back and forth between these two

channels by pressing RE T U R N+.

RETURN+

With RE T U R N+ You can program your TV to always re t u rn to a specific channel. Press and hold down the RE T U R N+

button for three seconds. The message, "RETURNC H A N N E L P R O G R A M M E D ! " will appear on-screen. Now

when you scan through the channels, pressing RE T U R N+ will bring you back to your programmed channel.

To cancel the RE T U R N+channel, press and hold the RE T U R N+button for three seconds. The message "RETURN

C H A N N E LC A N C E L L E D ! " will appear on-scre e n .

• Pressing any number key or turning off the TVwill also cancel the RE T U R N+c h a n n e l .

• Press the PO W E Rbutton on the remote control or the front panel of the TV. The On Timer will glow re d .

• Make sure the TV/CAT Vswitch on the remote is set to TV. Move the switch to CAT V only if you plan to operate

a cable box. On the CATV setting the remote will only operate the cable box functions.

• To turn the power off, press the PO W E Rbutton again. The On Timer will go out.

• The On Timer lamp will glow green when the On/Off Timer is set (page 23), even when the TV power is off.

POWER

To control the volume level, use the VO L U M E+/- b u t t o n s( ) on the remote control or on the TV's front panel.

Use the VO L U M E- ( ) button to lower the volume. Press the VOLUME+( ) button to raise the volume.

Press the MUTING button to instantly turn the volume to zero. Press the MUTING button again to return to the

previous volume level.

ADJUSTING VOLUMECHANGING CHANNELS

VOLUME 13

|||||||