VCR Plus+ 27

VCR Plus+

Your TV/VCR combo comes equipped with VCR
Plus+ technology. This function lets you program
your VCR by simply entering the VCR Plus+ code
number associated with the program you wish to
record.
• Before VCR Plus+ can be used, the VCR Plus+
guide channels must be programmed. See VCR
Plus+ Guide Setup in “Initial Setup” page 15 if you
have not yet programmed these guide channels.
Press the DAILY/WEEKLYbutton to select
how often a program should be recorded,
ONCE, DAILY, or WEEKLY
Press the SP/EP button to select SP or EP
recording speed. (See page 26 for more
on tape recording speeds)
Press the VCR PLUS+ button
The following screen will appear displaying a
summary of the information you just entered.
If the settings are correct, press the VCR PLUS+
button again to accept. The following message
will appear:
If you wish to make a correction, use the ( )
buttons to move to the item and the ( )
buttons to correct. Once corrected, press VCR
PLUS+ to accept the settings.
Press the TIMER button on the remote
control. The timer is now in standby
mode.
The REC TIMER lamp will glow green on the front
panel of the unit indicating that the timer has
been programmed. When the programmed start
time arrives, the REC lamp will glow red and
recording will begin. When the programmed stop
time arrives, the lamp will go out and the
recording will automatically stop. If there are other
pre-set recordings, the REC TIMER lamp will glow
green.

Timer Recording with VCR Plus+

Press VCR PLUS+ on the remote control
The VCR Plus+ code screen appears.
Enter the VCR Plus+ code (a three-to-eight digit
number) of the program you wish to record using
the 10 key pad on the remote control.
The following screen will appear:
• If you enter the VCR Plus+ code incorrectly,
press CANCEL on the remote. The “Enter the
PlusCode” screen will reappear.
- - - - - - -
ENTER THE PLUSCODE
VCR Plus+ Codes can usually be found in most local newspaper television listings or in TV magazines. VCRPlus+ codes are
three-to-eight digit numbers usually printed after the program title or description in the TV listings.
VCR Plus+ and PlusCode are registered trademarks of Gemstar Development Corporation. The VCR Plus+ system is
manufactured under license from Gemstar Development Corporation.
NOTES:
1234
HOW OFTEN?
ONCE DAILY (M-F) WEEKLY
SELECT
RECORDING SPEED SP EP
IF ALL OK, CANCEL BY
PUSH
VCR PLUS+
CANCEL
DATE MON - FRI
START 2:30 PM
STOP 3:00 PM
CHANNEL 03
RECORDING SPEED SP EP
IF ALL OK, CANCEL BY
PUSH
VCR PLUS+
CANCEL
YOUR PROGRAM IS CONFIRMED
PUSH THE TIMER BUTTON