Caution
●Take note of the length, strength, pull and material (insulation) of the fall prevention wire
and use one with a wire strength of more than 20kg.
●The inner diameter of the ring section of the fall prevention wire mounted on the camera should be R4 mm to R5.5 mm and the outer diameter be R9 mm and below.
●The thickness of the screw head and the fall prevention wire (including the washer) should be 6 mm and below. If it is more than 6 mm, the screw will touch the ceiling and the camera cannot be installed horizontally.
●Use M4 fixing screws.
Memo:
●The wire should be insulated from the ceiling structure. If the ceiling structure is metal and insulation is not provided between the camera and the ceiling structure, image noise may occur.
6 Connect the cable (A 23 to 25)
Connect cables to the terminal of the ceiling clamping bracket.
The connection cables consist of the alarm signal cable, LAN cable and AC 24 V power cable.
This connects the unit to the network.
This connects to AC 24 V power.
CAlarm input/output signal terminal (A Page 25)
This connects to devices with alarm input/output terminals.
A LAN Cable
B Power cable
CAlarm signal cable
Note:
●Do not connect an AC 24 V cable to AC 110 V power supply. The camera internal circuit will be damaged. Should that happens, do not use the camera. Bring it to your nearest JVC dealer for repair. (charged separately)
●For safety reasons, turn on the power only after all the connection is complete.
●To supply AC 24 V, use an AC 24 V supplying power unit that is insulated from AC 100 V line.
7 Handling cables
Thread the provided wire clamp through the wire clamp fixing hole of the ceiling clamping bracket to tie all the wires.
Wire clamp fixing hole 
Tie here
Wire clamp
Note:
●To prevent the cables from tangling and coming off, be sure to thread a wire clamp through the wire clamp fixing hole to tie the cables.
19