PCMode

Installation

•Power off both Computer and Display before making any connections.

•Set your PC’s resolution correctly before con- necting to the TV. See the table in page 30 for supported modes.

•Use a D-SUB cable to connect the TV's PC input to the computer's RGB output terminal.

If you want to listen to the sound from the computer, use an audio cable to connect the PC AUDIO IN to the computer's sound output terminal.

￿￿￿3LQ￿0LQL￿'￿6XE￿&RQQHFWRU

•Tighten the screws of the Display cable until the connectors are fastened securely (fin- ger-tighten only).

Main Menu in PC mode:

Enter the main menu by pressing the “MENU” button on the remote control.

PC Picture Position Menu:

In the Main menu, select “PC Picture Position ” using ““ or “” button, then enter the

menu pressing ““ / “” or “OK” buttons..

Auto Position

If you shift the picture horizontally or vertically to an unwanted position, use this item to put the picture into correct place automatically.

•Select Auto position item by using ““ or “” buttons.

•Press “OK” button.

•Press “MENU” button or “BACK” button to store the value.

Warning: Auto position adjustment recommended to be done with the full screen image for the proper adjustment.

Horizontal Position

This item shifts the image horizontally to right hand side or left hand side of the screen.

•Select Hor. Position item by using ““ or “” button.

•Use ““ or “” button to adjust the value.

•Press “MENU” button or “BACK” button to store the value.

Vertical Position

This item shifts the image vertically towards the top or bottom of the screen.

•Select Ver. Position item by using ““ or “” button.

•Use ““ or “” button to adjust the value.

•Press “MENU” button or “BACK” button to store the value.

Dot Clock

Dot Clock adjustments correct interference that appear as vertical banding in dot intensive presentations like spreadsheets or paragraphs or text in smaller fonts.

•Use ““ or “” button to adjust the value. Clock Phase

Depending on the resolution and scan frequency that you input to the TV Set, you may see a muddy or noisy picture on the screen. In such a case you can use this item to get a clear picture by trial and error method.

• Use ““ or “” button to adjust the value.

- 23 -