JVC LVT0692-009A, LVT0693-001A Troubleshooting

– 24 –

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,

such as your dealer, for service.

Troubleshooting

Symptom

Unable to cancel the display demonstration.

No sound is heard.

Hard to listen to broadcasts because of

noise.

The disc sound is discontinuous.

The carrousel does not open or close.

The disc does not play.

The cassette holders cannot be opened.

Impossible to record.

Operations are disabled.

Unable to operate the unit from the remote

control.

Cause

Other buttons are pressed to cancel the

display demonstration.

Connections are incorrect or loose.

• Antennas are disconnected.

• The AM (MW/LW) loop antenna is too

close to the unit.

• The FM antenna is not properly extended

and positioned.

The disc is scratched or dirty.

• The AC power cord is not plugged in.

• The carrousel is locked.

The disc is placed upside down.

Power supply from the AC power cord has

been cut off while the tape was running.

Small tabs on the back of the cassette are

removed.

The built-in microprocessor may

malfunction due to external electrical

interference.

• The path between the remote control and

the remote sensor on the unit is blocked.

• The batteries are exhausted.

Action

Press DEMO on the unit. (See page 8.)

Check all connections and make

corrections. (See pages 6 to 8.)

• Reconnect the antennas correctly and

securely.

• Change the position and direction of the

AM (MW/LW) loop antenna.

• Extend the FM antenna at the best

position.

Clean or replace the disc. (See page 23.)

• Plug the AC power cord.

• Unlock the carrousel. (See page 16.)

Place the disc with the label side up.

Turn on the unit.

Cover the holes with adhesive tape.

Unplug the AC power cord and then plug it

back in.

• Remove the obstruction.

• Replace the batteries.

EN18-26.CA-MXG51R[B]_f 01.2.15, 8:54 PM24

Contents

Main CA-MXG51R INSTRUCTIONS CA-MXG51R[B].COVER_f 01.2.15, 8:49 PM1 LVT0692-009A [B] G-1 IMPOR TANT FOR LASER PRODUCTS CA-MXG51R CLASS 1 LASER PRODUCT Caution: Proper Ventilation G-2 SAFETY INSTR UCTIONS SOME DOS AND DONTS ON THE SAFE USE OF EQUIPMENT 1 Introduction About This Manual Precautions Installation Power sources Contents 3 Location of the Buttons and Controls Front Panel 4 Front Panel Display window Display Window 126 4 7 89 5 Remote Control 6 5 9 Getting Started Unpacking Putting the Batteries into the Remote Control 3 Connecting Antennas 7 1 terminals on the rear of the unit. 2 antenna cord into the terminal. 8 To connect audio equipment with an optical digital input terminal NOW, you can plug in the unit and other connected equipment FINALLY! Cancelling the Display Demonstration To start the display demonstration manually Common Operations Press CLOCK/TIMER. Turning On or Off the Power Saving the Power Consumption While on Standby ECO-mode Setting the Clock 10 Selecting the Sound Modes Adjusting the Volume To turn down the volume level temporarily Reinforcing the Bass Sound Listening to FM, MW, and LW Broadcasts Tuning in a Station Presetting Stations Tuning in a Preset Station 12 Receiving FM Stations with RDS Changing the RDS Information Searching for Programs by PTY Codes (PTY Search) Press PTY/EON. Press SELECT + or SELECT until the PTY code you want appears on the display. 13 Switching to a Traffic Announcement Temporarily Press and hold PTY/EON. 14 Playing Back CDs Loading CDs Press 0. Place one or two discs correctly on the front slots of the carrousel, with its label side up. If you wish to load a third disc, press DISC CHANGE on the unit or DISC SKIP on the remote control. 15 Basic CD Operations To exchange CDs during playback of another To skip to the another CD in the carrousel To stop play for a moment 16 Repeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray Lock Program other tracks you want. Press CD 6. Playing Back Tapes Pr ess TAPE 33 Playing Back a Tape Press EJECT (0) for the deck you want to use. Put a cassette in with the exposed part of the tape down. Recording Recording a Tape on Deck B Press EJECT 0 for the deck B. Put a recordable cassette in with the exposed part of the tape down. Close the cassette holder gently. 19 CD Synchro Recording Dubbing Tapes 20 Using the Timers Using Daily Timer How Daily Timer actually works Press CLOCK/TIMER repeatedly until DAILY appears on the Press CLOCK/TIMER again. 21 Select the pr eset station number. Press 4 or to set the volume level. Press SET to complete the Daily Timer setting. To turn on or off Daily Timer after its setting is done 22 Using Sleep Timer How Sleep Timer actually works On the remote control ONLY: Press SLEEP. Maintenance Handling cassette tapes Handling discs 24 Troubleshooting 25 Additional Information Description of the PTY codes: 26 Specifications Amplifier section CA-MXG51R Tuner CD player Cassette deck SP-MXG51R CONNECTION SPECIFICATIONS Design and specifications subject to change without notice. Connection Anschlu Raccordement Aansluiting Conexin Collegamento Ansluiting Liitnt Tilslutning Csatlakoztats Poczenia Zapojen