Basic Operations
The following operations are commonly used when you play any sound sources.
Operations hereafter will be explained using the buttons on the front panel.
You can also use the buttons on the remote control for the same functions if they have the same and similar names/marks.
Daily Operational Procedure | Selecting the Source to Play |
English
1Turn on the power.
•See “Turning On the Power” below.
2Select the source.
•See “Selecting the Source to Play” to the right.
3Adjust the volume.
•See “Adjusting the Volume” on page 10.
4Select the Surround or DSP modes.
•See “Activating the Surround Modes” (page 25) and “Activating the DSP Modes” (page 27).
Turning On the Power
Press STANDBY/ON 
(or STANDBY/ON 
AUDIO on the remote control).
The STANDBY lamp goes off.
Current source name appears.
VOLUME
Current volume level appears.
To turn off the power (into standby mode),
press STANDBY/ON 
(or STANDBY/ON 
AUDIO on the remote control) again.
The STANDBY lamp lights up.
Note:
A small amount of power is consumed in standby mode. To turn off
the power completely, unplug the AC power cord.
When you have connected digital source components using the digital terminals, first change the input mode for these components to the digital input mode (see page 11).
Press one of the source selection buttons.
Selected source name appears.
VOLUME
AUX | DVD | VCR | TV SOUND | CD | TAPE/CDR | FM | AM | |
|
|
|
|
|
| SOURCE NAME |
|
|
|
|
| On the front panel |
|
| |||
|
| TAPE/CDR | CD | DVD | AUX |
|
| |
|
|
| FM/AM | TV SOUND | VCR |
|
|
|
On the remote control
Notes:
•When connecting a CD recorder to the TAPE/CDR jacks, change the source name shown on the display. For details, see page 12.
•By pressing the one of the audio source selection
9
