
Troubleshooting
If you have a problem with your unit, check this list for a possible solution before calling for service.
General | iPod Operations |
The power plug is not inserted securely. Plug it in securely (P.5).
Motion Sensor is activated (P.6).
There is a time limit. Repeat the procedure again.
The
Connect a composite video cord securely to your TV (P.5).
Change the video input mode on your TV. For details, refer to the instruction manual for your TV.
The path between the remote control and the remote sensor on the unit is blocked.
Point it at the remote sensor on the front panel.
Signals cannot reach the remote sensor. Move closer to the unit.
The batteries are exhausted.
Pull out the insulation sheet (P.3).
The unit is turned off automatically 2 hours after it is turned on by Timer (P.20).


The battery is empty. Leave it connected for more than 10 minutes.
The unit is in ECO mode. Cancel the mode (P.10, P.13).
Radio Operations
Hard to listen to broadcasts because of noise. The FM antenna connection is incorrect or loose (P.4).
The FM antenna is not properly extended and positioned (P.4).
Timer Operations
Timer does not work. Timer starts working only when the unit is turned off (standby).
A power failure may have occurred. Set the clock first, then Timer again (P.20, P.21).
Snooze is activated (P.22).
If you do not press SNOOZE within 3 minutes after the timer sound starts, Snooze does not work (P.22).
23