JVC LVT2051-002A, XV-THG31, SP-THG51F manual Test, Initial Setting the Area Code, Rating, Password

5.1 Speaker Setup

Test

Press b / B to test the signals of each speaker. Adjust the volume to match the volume of test signals memorized in the system.

Front Left (Front L) → Center→ Front Right (Front R) → Rear Right (Rear R) → Rear Left (Rear L) → SubWoofer

LOCK (Parental Control)

Initial Setting the Area Code:

See the Area Codes on page 21.

1.Select the LOCK menu and then press B.

2.To access the LOCK options, you must input the password you have created. Input a password and press ENTER. Enter it again and press ENTER to verify. If you make a mistake before pressing ENTER, press CLEAR.

3.Select the first character using v / V buttons.

4.Press B and select the second character using v / V buttons.

5.Press ENTER to confirm your Area code selection.

Rating

Blocks playback of rated DVDs based on their contents. Not all discs are rated.

1.Select “Rating” on the LOCK menu then press B.

2.Input a password and press ENTER.

3.Select a rating from 1 to 8 using the v / V buttons. Rating 1-8:Rating one (1) has the most restrictions and rating eight (8) is the least restrictive.

Unlock: If you select unlock, parental control is not active and the disc plays in full.

4.Press ENTER to confirm your rating selection, then press SETUP to exit the menu.

Password

You can enter or change password.

1.Select Password on the LOCK menu and then press B.

2.Follow the step 2 as shown above (Rating).

To change the password, press ENTER when the “Change” option is highlighted. Input a password and press ENTER. Enter it again and press ENTER to verify.

3.Press SETUP to exit the menu.

If you forget your password

If you forget your password, you can clear it using the following steps:

1.Press SETUP to display the Setup menu.

2.Select the LOCK menu.

3.Input the 6-digit number “210499” and press

ENTER. The password is cleared.

Area Code

Enter the code of the area whose standards were used to rate the DVD video disc, based on the list on page 22.

1.Select “Area Code” on the LOCK menu then press B.

2.Follow the step 2 as shown previous paragraph (Rating).

3.Select the first character using v / V buttons.

4.Press ENTER and select the second character using v / V buttons.

5.Press ENTER to confirm your Area code selection.

OTHERS

This option has no selection on this set.

13