JVC Basic operation, FM radio, iPod, Disc/USB, External device, Turn on the power, Select a source, 3 Adjust the volume, Adjusting the audio input level, Note:

Basic operation

STANDBY lamp Remote sensor

FM radio

Turn on the power. 1

Select a source. 2 3 Adjust the volume.

Searching for stations

1

TUNER FM AUDIO IN

2

(Hold) (Hold)The station search stops when a station of sufficient signal strength is found.•To manually stop the search, press ¢ or 4.•When you press ¢ or 4 repeatedly, the frequency changes step by step.•When an FM program is broadcast instereo, the S (stereo) indicator lights up.

Improving the receptionTo improve the receptionMONO STEREO•When the monaural mode is activated, the stereo effect is lost.

Presetting stationsYou can preset up to 30 FM stations.While listening to a target station...

1

2Select a preset number.

3

To erase a preset station1Tune in to a preset station (see below).

2

3

Tuning in to a preset station

iPod

Notes on iPod connection

•When detaching the dock adaptor from the dock, pull up the dock adaptor with your fingernail or sharp

pointed tool using the slot.

Before viewing a video/picture from your iPod on your monitor:

Make the appropriate video setting on iPod. For details of the setting, see the instruction manual for iPod.

Stereo mini plug cord (not supplied)Headphones (not supplied)The HP indicator lights up when headphones are connected to the System.

• Be sure to turn down the volume before connecting or putting on the headphones.

DO NOT turn off the System with the volume set to an extremely high level; otherwise, the sudden blast of sound may damage your hearing, speakers, and headphones when you turn on the System or start playback.

Dock adaptor (supplied with the iPod or sold separately)

iPod

1

2

3

Note:PTY SEARCH does not function.

Be careful not to injure your fingertips or damage the terminal of the direct dock.

•DO NOT connect or disconnect the iPod when the System is turned on.

•Be sure to reduce the volume on the System to the minimum level before connecting iPod. Adjust the volume after starting playback.

•You cannot send any data to the iPod from the System.

•Do not carry the System with iPod connected. It might cause damage to the dock or you might drop the iPod.

•Do not touch or hit the iPod terminal pins or connector pins in the dock for iPod directly. Doing so might cause damage to the connector pins.

•iPod is charged through the dock when the System is turned on.

Playback operations*Information shown on the display differs depending on the type of the iPod.To play back/pause iPodPress iPod 6.To select a trackPress ¢ or 4.To fast-forward a trackPress and hold ¢.To fast-reverse a track:Press and hold 4.To play back at randomPress RANDOM repeatedly.To play back repeatedlyPress REPEAT repeatedly.To put iPod in sleep modePress and hold iPod 6.

Menu operationsTo display the menu/to go back to the previous menuTo select an item on the menuNotes:•Operate iPod touch itself in the following cases:–When operating the home button.–When selecting application icons on the home screen.–When dragging the slider.

•Sound distortion may occur when playing back audio sources with high recording levels. If distortion occurs, it is recommended to turn off the equalizer of iPod. For information on operating the iPod, see the instruction manual for iPod.

Label side

Playback operations

Repeat Play

REP TRK 1 Repeats the current track.

Program PlayWhile playback is stopped...

1

Resume PlayThis System stores the beginning of the stopped track.RESUMECanceled

Disc/USB

REP GRP

Repeats all tracks in the current group (MP3/WMA only).

2Select a track number (up to 32 tracks).

When you start playback again, it starts from the beginning of the stored track.

Stereo mini plug cord (not supplied)

To open the disc trayPress 0 on the main unit.

REP ALL	ALL Repeats all tracks.
REP OFF Off	Cancels.

• To cancel, press CANCEL.

• To clear the stored position, perform one of the

following operations:

External device

Playback operation				USB mass storage
1				class device
				Notes on USB mass storage class device connection
	TUNER FM		AUDIO IN	• Connect a USB mass storage class device when the
				System is turned off to prevent malfunction.
2 Start playback of the external device.				• Do not use a USB hub.
				• When connecting with a USB cable, use a USB 2.0 cable
				whose length is less than 1 m.
Adjusting the audio input level				• The USB mass storage class device is charged through
				the USB MEMORY terminal when “USB” is selected as
You can change the audio input level through the AUDIO IN jack.				the source.
				• You cannot connect a computer to the USB MEMORY
				terminal of the System.
				• Electrostatic shock at connecting a USB mass storage
				class device may cause abnormal playback of the
	HIGH	NORMAL

	device. In this case, disconnect the USB mass storage
• This function affects only the sound coming out through the	class device then reset the System and the USB mass
	storage class device.
speakers.
	• While playing back a file on a USB mass storage class
	device, do not disconnect the device. Doing so may
	cause malfunction on both the System and the device.

To play back/pause a discPress CD 6.To play back/pause a USB mass storage class device Press USB 6.

To select a track

Press ¢ or 4.

To fast-forward a track

Press and hold ¡.To fast-reverse a track

Press and hold 1.

To select a groupPress UP or DOWN.To stop playback

Press 7.

Random Play

1

		Plays tracks in the current group
RND GRP	RND	in a random order (MP3/WMA
		only).
RND ALL	RND ALL	Plays all tracks in a random
		order.
RND OFF	Off	Cancels.

2

or

3

or

•To check the programmed contents, press 4 or ¢.

•To erase the entire program, press and hold CANCEL. The PRGM indicator is turned off.

•To exit from Program Play, press 7. The PRGM indicator is turned off.– The stored program is kept.

– Press 7 twice.

– Open the disc tray.

– Disconnect the USB mass storage class device.

• This function cannot be used for Program Play.

Prohibiting disc ejectionYou can lock the disc tray.While the System is on standby...

(On the main unit)

(While holding...) LOCKED UNLOCKED

2