70 EN
Master Page: Left
GR-DVX707EG_37-79.fm Page 7 0
The audio track can be customised only when
recorded in the 12-bit and SP modes. (墌pg. 44)
1Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2While holding A.
DUB (D) on the
remote control, press
PAUSE (9). The
“9D” indicator
appears.
3Press PLAY (U), then
begin “narrating”.
Speak into the
microphone.
●To pause dubbing, press PAUSE (9).
4To end Audio Dubbing, press PAUSE (9), then
STOP (8).
To hear the dubbed sound during playback…
Set “12BIT MODE” to “SOUND 2” or “MIX”.
(墌pg. 38, 51)
NOTES:
●Sound is not heard from the speaker during Audio
Dubbing. To hear sound, connect optional
headphones to the headphone connector.
(GR-DVX707 only)
●When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
●If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
●If feedback or howling occurs during TV playback,
move the camcorder’s microphone away from the
TV, or turn down the TV’s volume.
●If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
●During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
●To perform Audio Dubbing while watching on the
television, make connections. (墌pg. 24, 25)
Audio Dubbing
PAUSE
PLAY
A.DUB
STOP
Remote sensor
Headphone connector
(GR-DVX707 only)
Speaker
Stereo microphone
Open the
connector cover.
9D
MIC
GR-DVX707 only
USING THE REMOTE CONTROL UNIT (cont.)
GR-DVX707EG_37-79.fm Page 70 Thursday, January 31, 2002 12:19 PM