72 EN
Master Page: Left
GR-DVX707EG_37-79.fm Page 7 2
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
NOTES:
●Before performing the following steps, make sure
that “TIME CODE” is set to “ON”. (墌pg. 38, 49)
●Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the
television, make connections. (墌pg. 24, 25)
1Play back the tape, locate the Edit-Out point and
press PAUSE (9). Confirm the time code at this
point. (墌pg. 38, 49)
2Press REW (
3
) until the Edit-In point is located,
then press PAUSE (9).
3Press and hold INSERT
(I) on the remote
control, then press
PAUSE (9). The “9I”
indicator and the Time
Code (min.:sec.)
appear and the
camcorder enters
Insert-Pause mode.
4Press START/STOP to begin editing.
●Confirm the insert at the time code you
checked in step 1.
●To pause editing, press START/STOP. Press it
again to resume editing.
5To end Insert Editing, press START/STOP, then
STOP (8).
NOTES:
●Program AE with special effects (墌pg. 38, 42)
can be used to spice up the scenes being edited
during Insert Editing.
●During Insert Editing, the date and time
information changes.
●If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Edting stops. (墌pg. 100, 101)
Insert Editing
PAUSE
START/STOP
INSERT
PLAY
REW
STOP
Remote sensor
12:34
9I
USING THE REMOTE CONTROL UNIT (cont.)
GR-DVX707EG_37-79.fm Page 72 Thursday, January 31, 2002 12:19 PM