JVC pmn Messageson the display, Changing the channel information, To tune in a preset channel, Remote, Message, control:, Solution, Main unit:, Possible cause

To tune in a preset channel

1Select XM as the source.

Remote	Main unit:
control:

2Select a preset number for the channel you store.See “How to Select Numbers” on page 9.

• You can also use 4/¢on the main unit.

Changing the channel information

While listening to the XM Satellite Radio, the currently selected channel information appears on the display. You can change the type of channel information.

	CH--- P--*	CH NAME
SIGNAL		NAME

CATEGORY TITLE

CH--- P--*	Channel number/Preset number
	*Preset number is displayed only for
	the channels which are preset.
CH NAME	Channel name
NAME	Artist name/feature
TITLE	Track/program title
CATEGORY	Category name
SIGNAL	Signal strength

When SIGNAL is selected, current signal strength is indicated on the display in 4 levels (NO SIGNAL, 1-3).

memo

•Last channel you were listening to will be displayed the next time you selected XM.

•When you tune in to another channel, the selected channel number appears on the display.

•When all the text information cannot be shown on the display at a time, the text scrolls.

•Some characters cannot be displayed correctly.

Messages on the display

When problems occur, a message appears on the display. In this case, refer to the following solution.

Message	Possible cause	Solution
NO SIGNAL	Signals are too weak.	Move the XM Mini-Tuner Home Dock near
		a south-facing window or where “Channel 1”
		can be heard clearly.
CHECK	The XM Mini-Tuner is not properly in-	Confirm the XM Mini-Tuner is fully seated
↔	stalled or the cable is not properly con-	in the XM Mini-Tuner Dock.
XM TUNER	nected.	Then check the connection (see page 17),
		and confirm the XM Mini-Tuner Dock cable
		is not damaged and fully seated in the XM
		terminal jack on the unit front panel.
CHECK	The XM antenna is disconnected from	Confirm the XM antenna is properly con-
↔	the XM Mini-Tuner Dock.	nected to the XM Mini-Tuner Dock (see
ANTENNA		page 17).
LOADING	This receiver is loading the channel in-	It takes a few minutes to complete. Wait until
	formation and audio data.	loading is finished.
OFF AIR	Selected channel is not currently broad-	Select another channel.
	casting any signal.
UPDATING	The latest encryption code is being up-	Wait until updating is finished.
	dated.
“---”	No text information for the selected	—
	channel is available.
“CH---”	Selected channel does not exist or is not	—
	subscribed yet.

20