JVC RA-P11BK manual

Getting Started

PORTABLE AUDIO SYSTEM

RA-P11BK

Supplied Accessories

After unpacking, check to be sure that you have all the following items.

•Remote control

•AC adaptor

•Attachments (6 types)

•Rubber pads (A type×2, B type×2)

•CR2025 (×2) lithium coin batteries One is loaded on the remote control at the factory.

Preparation of the Unit

Prepare the Remote Control

•When you use the remote control for the first time, pull out the insulation sheet.

Replacing the Battery in the Remote Control

•Insert the battery into the remote control by matching the polarity (+ and –) correctly.

Insulation sheet

(Front side)

Lithium coin battery (CR2025)

(Rear side)

Warning

•Store the battery in a place where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately.

•Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Doing any of these things may cause the battery to give off heat, crack, or start a fire.

•Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat, crack, or start a fire.

•When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to give off heat, crack, or start a fire.

•Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat, crack, or start a fire.

•Dispose of battery in the proper manner, according to federal, state, and local regulations.

•The batteries (battery pack or batteries installed ) shall not be exposed to excessive heat source such as sunshine, fire or the like.

Loading batteries for the Unit (The battery power supply)

Insert three batteries to each compartment (six batteries total). Be sure to match the poles (+/-) correctly. While the AC adaptor is connected to the wall outlet, the unit works without batteries.

R6 (SUM-3)/AA (15F) (not supplied)

CAUTION:

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Thank you for purchasing a JVC product.

Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit.

INSTRUCTIONS

LVT1686-002A	EN
	©2006 Victor Company of Japan, Limited	1106NSMCREBET
[C]

Warnings, Cautions and Others / Mises en garde, précautions et indications diverses

Open the battery compartment

cover by pressing the small tab.

Close the cover in the order shown by the numbers.

9V 1.5A

FM wire antenna

(Pass through the notch in the cover)

Loading batteries for the Clock

Be sure to match the poles (+/-) correctly.

Lithium coin battery		Side of the battery
(CR2025) (supplied) Plus terminal	Plus terminal

Press the tab to open	Insert the battery with pushing the plus	Close the cover in the order
the cover.	terminal up to be sure the terminal	shown by the numbers.
	contacts the side of the battery.

Time to change the battery

Connecting the AC adaptor

To a wall outlet Plug the AC adaptor only after all connections are completed.

9V 1.5A

AC adaptor: AA-R9031 (supplied)

CAUTION:

To avoid risk of fire, and to prevent damage.

•Do not use AC adaptors except for the supplied AC adaptor.

•Do not use the supplied AC adaptor for other equipment.

Operating on the Remote Control

			1	SOURCE button
				Switch the sound source.
				FM MODE button
			2
	5			Switch FM stereo/monaural.
			3	MUTING button
				Turn off the sound. Return to original mode by
1		6		pressing again.
				PRESET +/- button
		7	4
				Select a registered FM radio station (P01 to 20).
2

(For U.S.A)	(For U.S.A)
	CAUTION
	Changes or modifications not approved by JVC
	could void the user’s authority to operate the
	equipment.
	For Canada/pour le Canada
	THIS DIGITAL APPARATUS DOES NOT
	EXCEED THE CLASS B LIMITS FOR
	RADIO NOISE EMISSIONS FROM DIGITAL
	APPARATUS AS SET OUT IN THE
	INTERFERENCE-CAUSING EQUIPMENT
	STANDARD ENTITLED “DIGITAL APPARATUS,”
	ICES-003 OF THE DEPARTMENT OF
	COMMUNICATIONS.
	CET APPAREIL NUMERIQUE RESPECTE LES
	LIMITES DE BRUITS RADIOELECTRIQUES
	APPLICABLES AUX APPAREILS NUMIRIQUES
	DE CLASSE B PRESCRITES DANS LA NORME
	SUR LE MATERIEL BROUILLEUR; “APPAREILS
	NUMERIQUES”, NMB-003 EDICTEE PAR LE
	MINISTRE DES COMMUNICATIONS.

Precautions

•Install in a place which is level, dry and neither too hot nor too cold–between 5°C and 35°C.

•Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System.

DO NOT install the System in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

•Leave sufficient distance between the System and the TV.

•Keep the speakers away from the TV to avoid interference with TV.

As the battery is running out, the display indication dims or the alarm may beep at the time the alarm is not set at. Replace the battery in such cases.

Troubleshooting

If you are having a problem with your System, check this list for a possible solution before calling for service.

In These Cases	Check the following points
Power does not come on.	• AC adaptor is not inserted securely. Plug in securely.
	• The batteries are exhausted.
No longer works.	Press the “RESET” button (see “Resetting the unit”).
Cannot set the iPod.	• Is the selected attachment compatible to your iPod? Confirm the
	compatibility of iPod and attachments in “iPod Compatibility Chart”.
	• Is the attachment properly mounted on the unit? Make sure to mount the
	attachment properly.
Cannot operate iPod.	• Is the iPod firmly connected to the connector plug of the unit?
	• Is the iPod properly functioning? Test the iPod functions in stand alone
	condition.
iPod cannot be charged.	• Is the iPod firmly connected to the connector plug of the unit?
	• Is the AC adaptor connected? Make sure the AC adaptor plug is pushed in
	all the way.
	The iPod cannot be charged while the Unit is operated on batteries.

	8	5	iPod 6button
3			Play/pause the iPod.
4		6	button
			Switch the backlight on/off.
			4/¢button
		7
			Fast-forward/rewind the iPod song.
			Change frequencies to tune in to FM radio
			station.
		8	VOLUME +/- button
			You can adjust the volume level from 00 to a
			maximum of 20.

NOTES

•Point the remote control at the remote control sensor on the front panel.

•The remote control sensor is designed to receive signals from up to approximately 7 m distance when the remote control is pointed directly. If the remote control is pointed with an angle, the distance may become shorter.

Specifications

Model	RA-P11BK
Type	Portable audio system

(For U.S.A)

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

•Rating label is placed on the exterior of the bottom.

•L’étiquette des caractéristiques nominales se trouve sur l’extérieur du coffret.

(For U.S.A)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: Front: No obstructions and open spacing.

Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.

Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more.

Attention: Aération correcte

Pour prévenir tout risque de décharge électrique ou d’incendie et éviter toute détérioration, installez l’appareil de la manière suivante:

Avant: Bien dégagé de tout objet.

Côtés/dessus/dessous: Assurez-vous que rien ne bloque les espaces indiqués sur le schéma ci-dessous.

Dessous: Posez l’appareil sur une surface plane et horizontale. Veillez à ce que sa ventilation correcte puisse se faire en le plaçant sur un support d’au moins dix centimètres de hauteur.

Front	15cm	Side	15cm
Face		Côté
15cm		15cm	15cm
		10cm

	• For iPod 3rd Generation, set the “CHARGING SWITCH” to “FIREWIRE”
	(see “Charging the iPod”).
Hard to listen to broadcasts	The FM antenna is not properly extended and positioned.
because of noise.
Unable to operate the System	• The path between the remote control and the remote sensor on the
from the remote control.	System is blocked.
	• The batteries are exhausted.
When the volume level is	The unit’s battery runs low (The “---” (Low battery) appears on the display).
manually set higher than “08”,	Replace the batteries with new ones.
the unit automatically lowers
the level to “08”.

Resetting the unit

If “Troubleshooting” does not eliminate malfunctioning (failure to operate or display properly, etc.), press the “RESET” button on the rear of the unit with something having a sharp point, while the unit is turned on. After pressing “RESET” button, unplug the AC adaptor and wait a while before plugging it again.

• When using “RESET” button, make sure the lithium coin battery is loaded.

• While resetting the unit, the clock is also reset. Adjust the clock after resetting the unit.

Amplifier	Power Output			4W x 2
				1kHz 10% THD, 6Ω
Input Sensitivity/ Impedance	AUX Input			250mV/47kΩ
	Tuning Range			87.5MHz - 108.0MHz
FM Tuner	Frequency Step			100kHz
	Preset Stations			20
Speaker	1way full range, diameter 35mm x2
Input Terminal	External DC IN ( for AC adaptor)
	AUX IN (mini jack)
Power Source	DC9V	1.5A (EXTERNAL DC IN)
	DC9V	(SIZE R6, AA BATTERY OR EQUIVALENT x6)
	DC3V	(CR2025, for the clock)
AC adaptor	Input : AC 110-240V			, 50/60Hz
	Output : DC 9V		1.5A
Dimensions (W x H x D)	(W) 331 mm x (H) 71 mm x (D) 98 mm
Weight (Without batteries)	0.7kg
Accessory	See Supplied Accessories

Specifications and appearance are subject to change without prior notice.