PORTABLE AUDIO SYSTEM

RA-P50W/RA-P51B

Specifications

Model

 

 

 

 

 

 

RA-P50W/RA-P51B
Type
Portable audio system

 

 

 

Amplifier
Power Output

4 W x 2

 

 

 

 

 

1 kHz 10 % THD, 6 Ω

 

 

 

 

 

 

Input Sensitivity/ Impedance
AUDIO IN
250 mV/47 kΩ

 

Band

FM

Tuner
Tuning Range
87.5 MHz - 108.0 MHz
Frequency Step
100 kHz

 

 

Preset Stations

20

 

Speaker
1way full range, diameter 50 mm x 2
Input Terminal
External DC IN (for AC adapter)
AUDIO IN (mini jack)

 

 

 

 

 

 

 

iPod connector
Output Power : DC 5 V

 

500 mA

 

Power Source
DC 9 V

 

1.5 A (EXTERNAL DC IN)

 

DC 9 V

 

(SIZE R6, AA BATTERY OR EQUIVALENT x 6)

 

 

DC 3 V

 

(CR2025, for the clock)

 

 

 

0.5 W (in Standby mode)
Power Consumption
13 W (Power On mode)

 

6 W (in Standby mode, with iPod devices connected)
AC adapter
Input : AC 110-240 V
, 50/60 Hz 0.5A
Output : DC 9 V

 

1.5 A

 

 

Dimensions (W x H x D)
(W) 310 mm x (H) 88 mm x (D) 93 mm

(12-1/4" x 3-7/16" x 3-11/16")

 

1. Getting Started

nSupplied Accessories
After unpacking, check to be sure that you have all the following items.
AC adapter AA-R9028 (For RA-P50W) or, AA-R9031 (For RA-P51B)

CR2025 lithium coin battery (Loaded on the back panel of the Unit at the factory.)

Warning

Store the battery in a place where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately.

Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Doing any of these things may cause the battery to give off heat, crack, or start a fire.

Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat, crack, or start a fire.

When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to give off heat, crack, or start a fire.

Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat, crack, or start a fire.

Dispose of battery in the proper manner, according to federal, state, and local regulations.

For USA-California Only

This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material – special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/perchlorate
n Preparation of the Unit

 

u Turn the Unit over to the back side and remove the

Back panel of unit

insulation sheet before using for the first time.

 

The display of the Unit lights up and shows the default clock.
Insulation Sheet
Pull
uLoading batteries for the Unit (The battery power supply)

Insert three batteries to each compartment (six batteries total). Be sure to match the poles (+/-) correctly. While the AC adapter is connected to the wall outlet, the unit works without batteries.

Close the cover in the order shown by the numbers.

R6 (SUM-3)/AA

(15F) (not supplied)

For Customer Use:

Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference.

Model No.
Serial No.
Weight (Without batteries)
0.8 kg (1.8 lbs)
Accessory
See Supplied Accessories
Specifications and appearance are subject to change without prior notice.

1 1

CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
FM wire antenna
u Connecting the AC adapter

CAUTION:

To a wall outlet
To avoid risk of fire, and to prevent damage.
• Do not use AC adapters except for the
Plug the AC adapter
supplied AC adapter.

INSTRUCTIONS

EN

LVT2019-001A [J,C]

 

©2009 Victor Company of Japan, Limited
0509KMMCREBET

Warnings, Cautions and Others / Mises en garde, précautions et indications diverses

 

only after all connections
• Do not use the supplied AC adapter for

 

are completed.
AC adapter (supplied)
other equipment.

 

 

 

2. Basic and Common Operations

Press
Functions

 

Press

Functions

 

 

 

 

 

 

 

 

 

Press

Functions

 

 

• Light the display screen for 5 seconds when the power is turned off.

 

FM MODE
• Switch FM stereo/monaural when FM is

 

 

 

• Temporarily stop the alarm sound when the alarm is ringing

 

selected. See P3.

 

Select a source

 

 

 

 

 

 

 

(SNOOZE).

 

¢

(see P3~4)

 

 

iPod FM AUDIO IN

 

 

 

Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit.

Precautions

• Install in a place which is level, dry and neither too hot

nor too cold–between 5°C and 35°C (41°F and 95°F).

• Install the System in a location with adequate ventilation

(see “Stopping the alarm sound P4”)

4

• Switch on/off the backlight when the button is held down.

3/8

WARNING: TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.

For U.S.A

Caution: Changes or modifications not expressly approved by party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment

and receiver.
– Connect the equipment into an outlet on a

AVERTISSEMENT : POUR PRÉVENIR LES RISQUES D’INCENDIE OU DE CHOCS ÉLECTRIQUES, NE PAS EXPOSER CE APPAREIL À LA PLUIE OU À L’HUMIDITÉ.

Pour les Etats-Unis

Attention : Les changements ou les modifications qui ne sont pas explicitement approuvés par la partie responsable de l’observance pourraient mettre fin au droit de l’utilisateur d’utiliser le matériel.

Remarque: Cet appareil a été testé et il s’est avéré conforme aux limites applicables à un appareil numérique de classe B, en vertu de la Partie 15 des Règles de la FCC. Ces limites sont conçues de manière à assurer une protection raisonnable contre les interférences nuisibles dans une installation résidentielle. Cet appareil produit, utilise et peut émettre une énergie de haute fréquence et, s’

il n’est pas installé et utilisé en conformité avec les instructions, il peut causer des interférences nuisibles aux communications radio. Il n’y a, toutefois, aucune garantie que des interférences ne se produiront pas dans une installation particulière. Si cet appareil cause effectivement des interférences nuisibles à la réception de la radio ou de la télévision, ce qu’on peut établir en mettant l’ appareil en marche et à l’arrêt, nous encourageons l’ utilisateur à tenter de corriger l’interférence par une ou plusieurs des mesures suivantes :

Rating label is placed on the exterior of the bottom. L’étiquette des caractéristiques nominales se trouve sur l’extérieur du coffret.

to prevent internal heat buildup inside the System.

DO NOT install the System in a location

near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

Leave sufficient distance between the System and the TV.
Keep the speakers away from the TV to avoid interference with TV.
Précautions

Installez la chaîne dans un endroit plat, sec, et ni trop chaud, ni trop froid-entre 5°C et 35°C.

Installez la chaîne dans un endroit avec une bonne ventilation pour éviter tout échauffement intérieur de l’appareil.

N’INSTALLEZ PAS la chaîne dans en endroit proche d’une source de chaleur ou sujet à la lumière directe du soleil, à un poussière excessive ou à des vibrations.

Laissez suffisamment d’espace entre la chaîne et le téléviseur.

Éloignez les enceintes du téléviseur pour éviter toute interférence avec ce dernier.

 

See" 3. How to set the time,
Connector plug

 

 

6. How to set the TIMER"

 

 

 

 

Press

Functions

Press

Functions

 

Turns on or off the power

 

Select a preset.
When the power is turned off at volume level “15”

 

 

or higher, the unit automatically sets the volume

Press

Functions

level to “14” the next time it is turned on.

 

Turn off the sound.

Press

Functions

 

 

Return to the original mode by pressing

 

Set the Sleep Timer.

 

again.

 

See P4.

Press

Functions

 

 

 

 

 

Adjust the volume level from 00 to a

 

 

 

maximum of 20.

Press

Functions

 

 

 

• Switch on/off the SURROUND.

 

 

 

You can enjoy music with spatial and deep sound in this mode. (The

 

 

 

mode is not effective when the monaural is selected.)

 

 

 

• While the clock or the alarm time are set, return to the previous item.

 

 

 

See P3~4

 

 

circuit different from that to which the receiver is

connected.

– Consult the dealer or an experienced radio/TV

technician for help.
Réorienter ou déplacer l’antenne de réception ;
Accroître la séparation entre l’appareil et le récepteur ;

Brancher l’appareil dans une prise ou un circuit autre que celui auquel le récepteur est branché ;

Consulter un vendeur ou un technicien radio/TV expérimenté pour obtenir de l’aide.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

1.Front: No obstructions and open spacing.

2.Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.

3.Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand 15/16") or more.with a height of 10 cm (3-

Attention: Aération correcte

Pour prévenir tout risque de décharge électrique ou d’incendie et éviter toute détérioration, installez l’appareil de la manière suivante:

When adjusting the volume

00 - 20

When FM radio is selected
P01 - P20 (channel) /

 

87.5 - 108.0 MHz (frequency)
When the source is set to iPod and the
iPod (blinking)
alarm is set to TIMER PLAY

 

When the source is set to FM radio and
FM (blinking)
the alarm is set to TIMER PLAY

 

For Canada/pour le Canada

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMIRIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR; “APPAREILS NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS.

CAUTION
Attention
Battery shall not be exposed to excessive heat such

Les piles ne doivent en aucun cas être exposées à

as sunshine, fire or the like.

une chaleur excessive (lumière du soleil, feu, etc.).

1.Avant: Bien dégagé de tout objet.

2.Côtés/dessus/dessous: Assurez-vous que rien ne bloque les espaces indiqués sur le schéma ci-dessous.

3.Dessous: Posez l’appareil sur une surface plane et horizontale. Veillez à ce que sa ventilation correcte puisse se faire en le plaçant sur un support d’au moins dix centimètres de hauteur.

Front

15cm

Side

15cm

Face

(5-15/16")

Côté

(5-15/16")

15cm

 

15cm

15cm

(5-15/16")

 

(5-15/16")

(5-15/16")

 

 

10cm

 

 

 

(3-15/16")

1

Date

Current time/ alarm time

Day of the week
uExplanation of Icons
Off: current time / On: alarm time

Off: alarm off / On: alarm on / Blinking: alarm sounding (When “TIMER PLAY” is set)

Blinks while snoozing (the alarm is paused)
SLEEP Lighting when the sleep mode is selected.
When battery power is low

- - -

When trying to set alarm to TIMER PLAY while selecting AUDIO IN

SURROUND starts lighting when it is switched on.
“ST” is displayed when an FM stereo broadcast is received.

“MONO” is displayed when the monaural is selected. (see “Listening to FM Broadcasts ”)

Current time: Blinking / Other Clock Display: Lighting
"" is displayed when the sound is muted.

2