5
1[MENU] button (with an indicator)
When this button is pressed, the MONITOR OUTPUT 1
on the rear panel outputs a menu screen and the indi-
cator with this button lights up.
REF. : “MENU SCREEN SETUP” on page 25.
2[SET] button
While a normal screen is displayed (i.e. when a menu
screen is not displayed), pressing and holding this button
for more than 3 seconds generates a short beep, lights up
the KEY LOCK indicator 5 and then puts the unit to the
KEY LOCK status.
In the KEY LOCK status, all buttons as well as the PAN/
TILT control lever # on the control panel are inactive.
To release the KEY LOCK status, press and hold the SET
button again for more than 3 seconds.
While a menu screen is displayed, this button is used to
display a menu in a lower hierarchy level or to enter a set-
ting.
REF. : “MENU SCREEN SETUP” on page 25.
3[ALARM] indicator
This indicator blinks when an alarm signal is input.
REF. : “ALARM OPERATION” on page 17.
4[POWER] indicator
This indicator lights up when the POWER switch on the
rear panel is set to ON.
5[KEY LOCK] indicator
This indicator lights up when the unit is in the KEY LOCK
status.
REF. : “2 [SET] button” for the KEY LOCK status setting.
6[CAMERA] display
Shows the camera number of the camera signals output
from the MONITOR OUTPUT 1 connector .
REF. : “CAMERA SELECTION” on page 10.
7[POSITION] display
Shows the position number of the camera signals output
from the MONITOR OUTPUT 1 connector .
REF. : “POSITION SELECTION” on page 11.
1. INTRODUCTION
CONTROLS, CONNECTORS AND INDICATORS
[Control Panel]
SETUPSETUP
MENUMENU SETSET
SPEEDSPEED
IRISIRIS
AFAF
FOCUSFOCUS
ZOOMZOOM
OPENOPEN
FARFAR
TELETELE CLEARCLEAR /HOME/HOME
7
4
1
8
0
5
2
9
6
3
ENTERENTER
AUTOAUTO
PANPAN
OPTIONOPTION
1OPTIONOPTION
2
CAMERACAMERA
POSI-POSI-
TIONTION
AUTOAUTO
PATROLPATROL
CLOSECLOSE
NEARNEAR
WIDEWIDE
AUTOAUTO F-1F-1 F-2F-2 F-3F-3
PAN/TILTPAN/TILTLENSLENS
CAMERA/POSITIONCAMERA/POSITION
CAMERACAMERA POSITIONPOSITION
REMOTE CONTROL UNIT REMOTE CONTROL UNIT
RM-P2580RM-P2580
ALARM
POWER
KEY LOCK
1 2 4356 7