Using LAN card/LAN terminal
Streaming and Capturing Video
The
Capturing (save to disk) of video transmitted by means of streaming can be started/ended on the Client PC. There are three trigger modes that are supported that, in combination with the trigger mode of the provided application software, enable the VTR operator to start and stop the recording onto the PC hard drive.
●TRIG – This mode is used to simultaneously record video onto a DV tape and a PC disk. Recording to both is controlled by the REC and PLAY button on the
●SPLIT – This mode allows independent record to DV tape or PC disk. Recording to DV tape is controlled by the REC and PLAY button as normal. Recording to the PC disk is controlled by the VTR’s SET button. In this mode it is not necessary to have a tape loaded in the VTR. The PC user must have the trigger mode of Streamcapture or Streamproducer enabled.
●OFF – This disables the VTR operators’ control of the PC recording. VTR operation is as normal. The PC user can control the saving of the video on the computer. Instructions for using this mode can be found in the Trigger mode function of the Streamproducer Users Guide.
Memo
●When performing a different type of transmission, switch the PB/DV IN setting in the SYSTEM menu of the VTR. In addition, set the INPUT SELECT switch of the VTR to “DV”.
●Depending on the network or operational environment, there may be no video or audio, or the network connection may be disconnected quitting the capturing process. Although connection may be reconnected depending on the used viewer software, the capturing process will not be resumed.
28