Manuals / Brands / Home Audio / Speaker System / JVC / Home Audio / Speaker System

JVC CA-UXP400, SP-UXP400 Step 3: HookUp, For better FM/AM reception, AUX, (not supplied), AM loop antenna, To a wall outlet, Outdoor FM antenna, Audio cord (not supplied)

1 32

Download 32 pages, 1.37 Mb

Step 3: Hook Up

If you need more detailed information, see page 6.

Illustrations of the input/output terminals below are typical examples.

When you connect other components, refer also to their manuals since the terminal names actually printed on the rear may vary.

Turn the power off to all components before connections.

For better FM/AM reception

AM loop antenna

Keep it connected.

Outdoor FM antenna

(not supplied)

Vynile-covered wire (not supplied)

Extend it horizontally.

Disconnect the supplied FM antenna, and connect to an outdoor FM antenna using a 75 Ω wire with coaxial type connector (IEC or DIN45325).

AUX

AUDIO OUT

LEFT

RIGHT

White

Audio cord (not supplied)

Red

VCR, etc.

To a wall outlet

Plug the AC power cord only after all connections are complete.

Contents

Page IMPORTANT FOR LASER PRODUCTS Introduction Getting Started Before Operating the System Daily Operations—Playback Advanced Radio Operations Advanced Disc Operations Advanced Tape Operations Timer Operations Additional Information Precautions Installation Power sources Moisture condensation Others Step1: Unpack Step2: Prepare the RemoteControl Step 3: HookUp For better FM/AM reception AUX FM antenna (supplied) AM loop antenna (supplied) To assemble and connect the AM loop antenna Indications on the main display —Playback To turn off (stand by) the unit Listening to the Radio To select the band (FM or AM) To tune in to a station To preset the stations To tune in to a preset station PlayingBack a Disc To insert a disc To select a track To select a group (MP3 only) To locate a particular portion PlayingBack a Tape To insert a tape To change the tape running direction To reverse the tape automatically Adjusting the Volume Adjusting the Sound To emphasize rhythm feeling—RHYTHMAX To adjust the tone Changing the Display Brightness Settingthe Clock TurningOff the Power AutomaticallyONLY To turn off the unit after playback is over—AutoStandby To turn off the unit after a certain period of time —SleepTimer Searchingfor a Program by PTYCodes Switching Temporarilyto a Programof Your ChoiceAutomatically Description of the PTY codes NEWS AFFAIRS SPORT EDUCATE Programmingthe Playing Order— ProgramPlay To check the programmed contents To modify the program To exit from Program Play To exit from Random Play To repeat a particular portion—A-BRepeat Recordingon a Tape Synchronized Disc Recording To record the entire disc To record only your favorite track Settingthe Timer 3 Select the volume level 4 Select the volume level For Recording Timer: 2Set the hour then the minute for off-time 3Select a preset station number To turn off the Timer after its setting is done Learning More about This System Daily Operations—Playback (see pages 8 to 10) Daily Operations—Sound& Other Adjustments Advanced Radio Operations (see pages 13 to 15) Advanced Disc Operations (see pages 16 to 18) Troubleshooting General: Radio Operations: Disc Operations: Tape Operations: Specifications Amplifier section Tuner section CD player section Cassette deck section SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” Page Page SYSTEM COMPONENT MICRO P400-UX