JVC SX-LT55U manual Preparation

22.0 kg / 49.0 lb.

English

Contents
Warnings, Cautions and Others	............................................. 2
Preparation	2
Connection	3
Specifications	Back cover

Warnings, Cautions and Others

7Precautions for installation

•To avoid personal injury or accidentally dropping the unit, have two persons unpack, carry, and install the unit.

• Do not install the speakers on an uneven surface or in a place subject to vibration;

otherwise, they may fall over, causing damage or injury.

–Take the occurrence of earthquakes or other physical shocks into consideration when selecting the installation place, and secure the speakers thoroughly.

•To prevent deformation or discoloration of the cabinet, do not install the speakers where they are exposed to direct sunlight or high humidity, and avoid installation near air conditioning outlets.

•Speaker vibrations may cause howling. Place the speakers as far away from the player as possible.

•The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.

Then wait at least 30 minutes before turning on the TV’s

main power switch again.

Some TVs may still be affected even though you have followed the above. If this happens, move the speakers further away from the TV.

•Tuner reception may become noisy or hissing if a speaker is installed near the tuner. In this case, leave more distance between the tuner and the speakers or use an outdoor antenna for better tuner reception without interference from the speakers.

•Do not lean against the speakers, as the speakers could fall down or break, possibly causing an injury. Especially be careful that children do not lean against them.

7Precautions for daily use

•To maintain the appearance of the speakers

Wipe with a dry, soft cloth if the cabinet should become dirty. If very dirty, apply a small amount of water or neutral detergent to the cloth and wipe clean, then wipe with a dry cloth.

•To improve the sound field

–It is recommended to leave a space of more than 50 cm between the speakers and the wall.

–If the speakers are facing a solid wall or glass door, etc., it is recommended to furnish the wall with materials that absorb sounds, for example by hanging up thick curtains, to prevent reflections and standing waves.

•To use the speakers without any trouble

–Do not reproduce sounds at so high a volume that they are distorted; otherwise, the speakers may be damaged by internal heat buildup.

–When moving the speakers, do not pull the speaker cords; otherwise, the speakers may fall over, causing damage or injury.

Preparation

7Checking the supplied accessories

•	Feet (2)	•	Speaker grille (1)
•	Screws (4)	•	Spacers (4)

If any item is missing, contact your dealer immediately.

7Attaching the feet

To prevent the speaker from falling over, be sure to attach the supplied feet to the speaker.

•Take care not to drop the feet or speaker while assembling; otherwise, it may cause damage to the floor or injury.

•Ensure enough space for assembly and installation.

•Place a large, thick cloth on the floor where you assemble the speaker, so you can protect the floor and the speaker itself.

•Do not touch the speaker units.

1Turn the speaker upside down.

Speaker units

2Attach the feet.

•Prepare a Phillips screw driver.

•Attaching the feet securely on the bottom of the speaker with the four screws as illustrated.

	Screw x 4
Foot	Foot	With the
		foot-spacer side
		facing up.
	Speaker section

3Install the speaker.

•Attach the supplied spacers under the feet if the speaker is not installed stably.

Put multiple spacers in piles under the feet if the gap cannot be filled enough by one spacer.

Spacer

7 To remove the speaker grille

To remove the speaker grille, insert your fingers at the bottom of the speaker grille, then pull upward.

To attach the speaker grille, put the projections of the speaker into the holes of the speaker grille.

•Do not press the speaker grille strongly.

2