Connection

7Precautions

Before connecting:

•Make sure to match the polarity (ª and ·) when connecting the speaker cords.

•Turn off the power to the amplifier before connecting the speaker system; otherwise, the speakers may be damaged.

•The impedance of the speaker is 6 Ω.

If this does not match with the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier.

•The maximum power handling capacity of the SX-WD5 is 100 W. Excessive input will result in abnormal noise and possible damage.

Daily operations and maintenance:

•Be sure to turn down the volume level on the amplifier to prevent unwanted noise before performing following operations:

–Turning on or off other components

–Operating the amplifier

–Tuning FM stations

–Fast-forwarding a tape

–Continuously reproducing high frequency oscillation or high pitch electronic sounds

–Connecting or disconnecting a microphone

•When using a microphone, do not aim it at the speakers or use it near the speakers; otherwise, the howling which occurs may damage the speakers.

•Before replacing the cartridge, always turn off the power both to the amplifier and to the turntable; otherwise, the clicking noise may damage the speakers.

7Connecting the speaker system to the amplifier

• Twist and remove the insulation at the end of each speaker cord before connecting.

1 2 3

· terminal

ª terminal

(Black hoop)

(Red hoop)

 

 

To the speaker ª

 

 

terminal of amplifier

Silver

Copper

To the speaker ·

 

terminal of amplifier

 

 

English

3