JVC TH-M508 Connecting the satellite (front, center, surround) speakers

Connections This page is for

Connecting the satellite (front, center, surround) speakers

Before connecting the speaker cords;

Twist and pull the insulation coat off and remove.

	Powered subwoofer
	SP-PWM508
Front speakers
SP-THM508F	Speaker cord (supplied)

• Connect the silver cords to the black (r) terminals.

• Connect the copper cords to the (q) terminals referring to the table below:

FRONT SPEAKERS (RIGHT)	Red
FRONT SPEAKERS (LEFT)	White
CENTER SPEAKER	Green
SURROUND SPEAKERS (RIGHT)	Gray
SURROUND SPEAKERS (LEFT)	Blue

Surround speakers

SP-THM505S

(Bottom)

4 m

Speaker (rear side)	Top of the base plate	10 m
	FRONT	4 m Center speaker
		SP-THM508C

Screw M4 x 20 mm (supplied)

		Route the speaker cord
Base plate	Copper	through the hole on the
		bracket.
Silver
	Red
Black

CAUTION

•When you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer.

•DO NOT connect more than one speaker to one speaker terminal.

•When installing the satellite speakers on the wall;

•Be sure to have them installed on the wall by a qualified personnel. DO NOT install the satellite speakers on the wall by yourself to avoid unexpected damage from their falling off the wall due to incorrect installation or weakness in wall structure.

•Care must be taken in selecting a location for speaker installation on a wall. Injury to personnel or damage to equipment may result if the speakers installed interfere with daily activities.

9