Installation

Mounting the camera directly to the ceiling or on the wall

When mounting to a wall, replace areas indicated as "ceiling" in the procedures by "wall".

mSetup

1Open a hole in the ceiling (Φ 30 mm, 1-1/8 inches), and draw the fall prevention wire, power supply cable and coaxial cable out from the ceiling (fall prevention wire is not included)

30 mm

Power cable

(1-1/8 inches)

 

Fall prevention wire

 

(not supplied)

Approx. 100 mm

 

Coaxial cable

(3-7/8 inches)

2Remove the dome cover

As illustrated in the diagram, hold the dome cover such that the position alignment mark comes between the thumb and index finger, and turn the cover in the counter clockwise direction to remove the cover. (Refer to page 24 for more details about position alignment mark.)

3Remove the inner dome from the catches (two locations)

The inner dome can be easily removed by turning it about 45 degree and grip from both sides near the catches as illustrated in the diagram.

2

Position alignment mark

Catches ( 2)

3

Fall prevention sheet

4Set the switches for video images (A page 9)

13