JVC UX-G1 Listening to FM and AM Broadcasts, Setting the Tuner Interval Spacing, Tuning in to a Station, To reduce the beat when listening to an AM station

BEAT CUT

Listening to FM and AM Broadcasts

Continued

Setting the Tuner Interval Spacing

2 Press and hold ¢ or 4

(or ¡/¢ or 4/1 on

You can select 10 kHz or 9 kHz apart for the AM tuner

the unit) for more than 1

interval spacing and 100 kHz or 50 kHz apart for the FM

second.

tuner interval spacing.

• ¢ (¡/¢): Increases the frequencies.

• You need to do this setting separately for each band.

• 4 (4/1): Decreases the frequencies.

On the unit ONLY:

The unit starts searching for stations and stops when a

1 Press TUNER/BAND to select either

station of sufficient signal strength is tuned in.

BAND

• If an FM program is broadcast in stereo, the ST (stereo)

TUNER/

“FM” or “AM.”

indicator lights up on the display (only when the

The unit automatically turns on and tunes in to

reception is good).

the previously received station—either FM or

AM.

To stop during searching, press ¢ or 4 (or ¡/¢ or

• Each time you press the button, the band alternates

4/1 on the unit).

between FM and AM.

Press VOLUME + while holding

When you repeatedly press ¢ or 4 (or ¡/¢ or

down 7.

4/1 on the unit)

• Each time you press VOLUME +, the

The frequency changes step by step.

CONTROL

interval spacing alternates as follows:

To change the FM reception mode

While selecting the AM tuner

On the remote control ONLY:

10K (10 kHz) Ô 9K (9 kHz)

When an FM stereo broadcast is hard to receive FM MODE

or noisy, press FM MODE so that “MONO”

VOLUME

appears and the MONO indicator lights up on the

display. Reception will improve.

While selecting the FM tuner

To restore the stereo effect, press FM MODE again so that

100K (100 kHz) Ô 50K (50 kHz)

“STEREO” appears and the MONO indicator goes off. In

stereo mode, you can hear stereo sound when a stereo

program is broadcast.

English

When you change the setting

The preset stations are erased. You will need to preset the stations again. (See page 11.)

Tuning in to a Station

1 Press TUNER/BAND to select either TUNER/

BAND

“FM” or “AM.”

The unit automatically turns on and tunes in to the previously received station—either FM or AM.

•Each time you press the button, the band alternates between FM and AM.

To reduce the beat when listening to an AM station— Beat Cut

On the remote control ONLY:

While recording an AM broadcast, beats may be heard (which are never heard when listening to the broadcast without recording it).

If this occurs, press BEAT CUT repeatedly, while recording, until the beats are reduced.

•Each time you press the button, the display alternates between “CUT–1” and “CUT–2.”