JVC CA-UXNB7DAB, SP-UXNB7DAB, UX-NB7DAB Listening to the Radio, Basic Tuner Operations

Listening to the Radio

Basic Tuner Operations

Press

To

On the System On the remote

Each time you press the button, the band changes as follows:

DAB

AM FM

The selected band and frequency appear on

Select a bandthe main display.

• When an FM stereo broadcast with sufficient signal strength is tuned in, the ST (stereo) indicator lights on the display.

	When you change the source to DAB for the first time after plugging in the
	AC power cord, the System automatically scans the DAB bands for available
	ensembles. (See page10.)
	• For general information of DAB, see “What is DAB system?” on page 10.
Change the FM reception mode			Press to improve reception.
			The MONO indicator lights up on the display.
(When a stereo broadcast is	—		Reception will improve though the stereo
hard to receive or noisy)			effect is lost.
			To restore the stereo effect, press again.
For FM/AM
			Press and hold for more than 2 seconds.
			The System starts searching for stations and
			stops when a station of sufficient signal
Select a frequency	or	or	strength is tuned in.
			• Press during searching to stop.
			• Press repeatedly to change the frequency
			step by step.
			Press to select a preset number for the preset
Tune in to a preset station	—	or	station.
			• For presetting stations, see page 12.
For DAB
			Press and hold for more than 2 seconds.
Select an ensemble			• You can select from the ensembles
	or	or	scanned by the ensemble scanning.
Select a service (either primary			Press briefly while tuning in to an ensemble.
or secondary)
			Press briefly to select a preset number for the
Tune in to a preset service			preset service.
			• For presetting services, see page 12.
	—		Press and hold for more than 2 seconds.
		or	The frequency changes every second
Tune in to all ensembles			through all ensembles regardless of the
			signal status.
			• Press and hold the button until the desired
			ensemble is reached.

9