Removing the dome cover and inner dome
•Turn the dome cover counterclockwise to remove it.
•Turn the inner dome 45 degrees counterclockwise and grasp the inner dome near the stops (two locations) to remove it.
1
Dome cover
2 
Inner dome
Knob (two
locations)
Fall prevention sheet
When mounting the camera with cables pulled out from the side
If you cannot cut a large enough hole in the ceiling or walls, connect by pulling the cables out through the opening in the side of the camera body.
Power cable
Alarm cable
Audio cable
LAN cable
Monitor output cable
| Approx. Φ 30 mm |
Fall prevention wire | Alarm cable |
(Prepared by customer) | |
Monitor output cable | Power cable |
| |
LAN cable | Audio cable |
|
Side opening for cables
Mounting the Camera
Note Read before starting work.•Special skills are required to install this unit.
•Install this unit on a location that is strong enough to hold it.
•Make sure you turn off the power supply to the device before starting work.
•When you attach the camera body to the ceiling, be sure to wear safety goggles to protect your eyes from falling objects.
Opening a hole (approx. Φ 30 mm) on the ceiling or wall
Note
•Take note of the length, strength and pull of the fall prevention wire. For the fall prevention wire use the insulation material.
Memo
•When you directly mount the camera on the ceiling, use the ceiling mount bracket
•To mount the camera using an electrical box, consult your dealer or a JVC Service Center near you.
Open a hole in the ceiling or wall (approx. Φ 30 mm), and pull out the fall prevention wire and cables from the hole (the fall prevention wire and cables are not provided).
Cabling
LAN cable 
Fall prevention wire
|
| Soldering or crimping |
Monitor output |
|
|
cable |
|
|
Alarm cable |
| Wrapping insulation |
Audio cable | ||
Power cable | tapes |
LAN cable Wire clamp
Connect the AC 24 V power cable, alarm cable, and audio cable to their respective connectors by crimping them or soldering them.
Wrap unused connectors and the ends of unused cables with insulation tape.
Make sure the LAN cable is completely inserted into the connector.
Securing cables
Knob | Camera |
(two | body |
locations) |
|
Fastening screw
Inner
depression
Inner dome
Dome cover setscrews
Dome cover
Dome cover protective sheet
(The
Note |
|
• The inner diameter of the ring section of |
|
the fall prevention wire should be between | Φ 3.1 to Φ 5.5 mm |
Φ 3.1 mm and Φ 5.5 mm. |
•Securely lock the LAN cable so that it will not be disconnected.
•Be sure to properly ground the PoE power sourcing equipment before use.
•If you use both the AC 24 V power cable and the
Memo
•Put the cables into the hole that you opened on the ceiling or wall after connecting.
Align the mounting direction mark (
) with the shooting direction, and mount the camera body on the ceiling or wall
Note
•Mounting hole is Φ 4.5 mm.
•Do not use a flat head screw.
•If you use an impact driver, tighten by hand. Otherwise, the case may be damaged.
•Use the appropriate screws and tighten securely.
•Use a screw with a head between Φ 6.5 mm and Φ 11 mm.
Align the mounting direction mark ( ) with the shooting direction, and mount the camera.
Memo
•When you mount it on the wall, make the mounting direction mark (
) face up.
Mounting hole (Φ 4.5 mm)
Attachment screw
(Prepared by customer)
Memo
•Secure the dome cover using two dome cover setscrews as required.
Securing the fall prevention wire
Secure the fall prevention wire using the wire setscrew.
Fall prevention wire setscrew
Fall prevention wire
Memo
Securing the LAN cable
Secure the LAN cable using the wire clamp.
1 Loosen the attachment screw | Wire clamp |
of the wire clamp until it is |
|
loose but not disconnected. |
|
Attachment screw of the wire clamp
2 Roll the wire clamp around the LAN cable.
3Fasten the free end of the wire clamp with the attachment screw of the wire clamp.
4Tighten the attachment screw of the wire clamp and fix the LAN cable.
• Take note of the length and strength of the fall prevention wire. Use wire |
|
made of insulated material. Make the wire length as short as possible. | 2 |
☞ Continue to next page |