1 Introduction

Thank you for purchasing the camera. Before installing it, please verify your model and read this guide carefully. See the INSTRUCTIONS located on CD-ROM for more information about setting up your camera.

Unpack Everything

HD IP CAMERA

WARRANTY CARD

SAFETY PRECAUTIONS

QUICK GUIDE

8-PIN TERMINAL BLOCK for alarm input/output

CD-ROMcontaining INSTRUCTIONS and IP Finder software

Prepare for Installation

Select the lens to use with your camera. This camera supports the use of a manual iris or DC iris lens . When using a DC iris lens, it should be connected to the camera via the 4-pin square socket located at the side of the camera.

Mount the Camera

1. Attach the camera to a pending mount.

Insert the screws on the camera stand into either of the screw holes on the base. Then tighten them up.

2.Mount the camera onto the ceiling/wall and fasten it securely.

3.Connect the Safety Wire(Fall Prevention Wire, not supplied) to the camera and the wall/ceiling.

Warning

To prevent the camera from falling off, ensure that it is connected to a firm place

(ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not

supplied).

Pay also careful attention to the length, strength, wiring, and material (insulating

properties) of a Safety Wire (fall prevention wire) to be used. The length should

be as short as possible within the permissible range of the mounting length. The

wire should be strong enough to withstand the total weight of this product and the

fixer. (Pay also attention to the finishing at the end of the wire.)

Must be isolated camera and the wall/ceiling which are connected by a Safety

Caution

Wire (Fall Prevention Wire).

2

Page 3
Image 3
JVC VN-T16/U manual Introduction, Unpack Everything, Prepare for Installation, Mount the Camera