Setting Using Internet Explorer
Details Page
This page is for performing detailed network setting.
This page can be used during access using AadminB.
●Press the [OK] button to enable the new settings.
●If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the entry will be denied. Press the [Cancel] button to restore the invalid entry to the current value.
A
B
C
D
E
F
A JPEG TOS(DS | For setting the TOS value of IP packets in which JPEG is stored. |
field) | The upper six bits out of the eight bits that make up the TOS value belong to |
| DSCP. |
| This upper six bits can be set. The lower two bits are “0”. For example, upon |
| setting to “255”, the lower two bits are converted to “0”, and the value |
| becomes “252”. |
| TOS values are used in networks that support QoS. By setting QoS for the |
| network switch, routing can be done by giving priority to packets with a larger |
| TOS value. |
|
|
B MPEG4 TOS(DS | For setting the TOS value of IP packets in which MPEG4 is stored. |
field) | For details, refer to the [JPEG TOS(DS field)] item above. |
|
|
C TTL Unicast | For setting the TTL value of JPEG/MPEG4 packets that are to be sent via |
| TCP. |
| The loss of unreceived packets from the network is faster when the TTL |
| value is smaller. |
|
|
D TTL Multicast | For setting the TTL value of JPEG/MPEG4 packets that are to be sent via |
| multicast. |
|
|
E MTU | For setting the maximum packet size for storing JPEG/MPEG4. |
| [Setting range: 1280 ~ 1500] |
|
|
F Negotiation | For setting the negotiation of the network. |
| When a value other than AAutoB is selected, do not set the network device to |
| be connected to AAutoB. Ensure that it is set to the same value as |
|
|
56